Mazda CX-5 Service & Repair Manual: Transfer Oil Replacement [Fw6 Ax EL]
1. Remove the front under cover No.2..
2. Remove the drain plug with the washer.
3. Drain the oil into a suitable container.
4. Tighten the drain plug with a new washer.
-
Tightening torque
-
40—58 N·m {4.1—5.9 kgf·m, 30—42 ft·lbf}
5. Remove the oil level plug with the washer and add the specified amount and type of oil through the oil level plug hole until the level reaches the bottom of the oil level plug hole.
-
Transfer oil
-
Specified oil grade: API Service GL?5
-
Specified oil viscosity: SAE 80W-90
-
Capacity (approx quantity): 0.45 L {0.48 US qt, 0.40 lmp qt}
6. Tighten the oil level plug with a new washer.
-
Tightening torque
-
40—58 N·m {4.1—5.9 kgf·m, 30—42 ft·lbf}
7. Install the front under cover No.2..
Transfer Oil Inspection [Fw6 Ax EL]
1. Park the vehicle on level ground.
2. Remove the oil level plug with the washer.
3. Checking by hand, verify that the oil is near the brim of the plug hole.
If the oil level is low, ...
Transfer Oil Seal Replacement [Fw6 Ax EL]
Transfer oil seal (LH)
1. Drain the transfer oil..
2. Remove the transfer from the vehicle..
3. Insert a tape-wrapped flathead screwdriver into the lip area of the oil seal
(LH) as shown in the ...
Other materials:
D Pillar Speaker Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk board.
b. Trunk end trim.
c. Rear scuff plate.
d. Trunk side trim.
e. D-pillar trim.
3. Disconnect the connector.
4. Remove the screws.
5. Remove the D-pillar speaker.
6. While pressing the tab ...
Power Window Main Switch Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Inner garnish. (driver's side).
b. Front door trim. (driver's side).
c. Power window main switch.
3. Connect the power window main switch connector.
4. Connect the negative battery cable..
5. Measure t ...
Evaporative Emission (Evap) Control System
Purpose, Outline
Prevents release of evaporative gas into the atmosphere.
The intake manifold vacuum introduces evaporative gas to the intake manifold
via the charcoal canister and the purge solenoid valve.
System Diagram
U.S.A. and CANADA
Except U.S.A. and CANADA
...
