Mazda CX-5 Service & Repair Manual: Transfer Oil Replacement [Fw6 Ax EL]

Mazda CX-5 Service & Repair Manual / Drivetrain / Driveline / 4WD / Transfer Oil Replacement [Fw6 Ax EL]

1. Remove the front under cover No.2..

2. Remove the drain plug with the washer.

3. Drain the oil into a suitable container.

4. Tighten the drain plug with a new washer.

Tightening torque

40—58 N·m {4.1—5.9 kgf·m, 30—42 ft·lbf}

5. Remove the oil level plug with the washer and add the specified amount and type of oil through the oil level plug hole until the level reaches the bottom of the oil level plug hole.

Transfer oil

Specified oil grade: API Service GL?5
Specified oil viscosity: SAE 80W-90
Capacity (approx quantity): 0.45 L {0.48 US qt, 0.40 lmp qt}

6. Tighten the oil level plug with a new washer.

Tightening torque

40—58 N·m {4.1—5.9 kgf·m, 30—42 ft·lbf}

7. Install the front under cover No.2..

Transfer Oil Inspection [Fw6 Ax EL]

1. Park the vehicle on level ground. 2. Remove the oil level plug with the washer. 3. Checking by hand, verify that the oil is near the brim of the plug hole. If the oil level is low, ...

Transfer Oil Seal Replacement [Fw6 Ax EL]

Transfer oil seal (LH) 1. Drain the transfer oil.. 2. Remove the transfer from the vehicle.. 3. Insert a tape-wrapped flathead screwdriver into the lip area of the oil seal (LH) as shown in the ...

Other materials:

Initial Learning [Fw6 A EL, Fw6 Ax EL]
Introduction If the control valve body and oil pressure switch are replaced, always perform the initial learning. If the initial learning is not completed, engine rev-up may occur or shift shock may increase. DTC P06B8:00 is displayed while the initial learning has not been implement ...

Manual Transaxle Removal/Installation [C66 M R]
Removal 1. Disconnect the negative battery cable.. 2. Remove the plug hole plate.. 3. Remove the front under cover No.2.. 4. Remove the front under cover No.1.. 5. Remove the splash shield.. 6. Drain the manual transaxle oil.. 7. Disconnect and/or remove the following parts in the engin ...

Condenser Removal/Installation
1. Disconnect the negative battery cable.. 2. Discharge the refrigerant.. 3. Remove the front under cover No.1.. 4. Drain the engine coolant.. 5. Remove the following parts: a. Plug hole plate. b. Air cleaner, air hose and fresh air duct component. c. Coolant reserve tank. d. Cooling ...