Mazda CX-5 Service & Repair Manual: Rear Buckle Removal/Installation

Mazda CX-5 Service & Repair Manual / Restraints / Rear Buckle Removal/Installation

1. Switch the ignition to off.

2. Disconnect the negative battery cable and wait for 1 min or more

3. Press the release switch, then disconnect the rear center seat belt and rear buckle.

4. Fold down the rear seat back.

5. Remove the trunk board..

6. Remove the bolt.

7. Remove the rear buckle (RH) and rear buckle (LH).

8. Install in the reverse order of removal..

Rear Buckle Installation Note

1. After installing the rear center seat belt, place the release switch of the rear buckle so that it faces the vehicleвЂ™s inner-side as shown in the figure.

Pre Tensioner Seat Belt [Two Step Deployment Control System]

Purpose The pre-tensioner seat belt retracts and tightens the seat belt webbing to protect the front passengers during a collision. Function The pre-tensioner seat belts operate ...

Rear Seat Belt Removal/Installation

CAUTION: The ELR (emergency locking retractor) has a spring that will unwind if the retractor cover is removed. The spring cannot be rewound by hand. If this occurs, the ELR will not wor ...

Other materials:

Refrigerant Charging
CAUTION: Do not use a different type of refrigerant or charge beyond the specified level. Otherwise, cooling ability will be lowered and the A/C compressor could be damaged. Charging Recycled HFC-134a Refrigerant 1. Connect an HFC-134a recovery/recycling/recharging device to the ...

Air Mix Actuator [Full Auto Air Conditioner]
Purpose The air mix actuator moves the air mix door in the A/C unit to adjust the temperature of the air blown from the air vent. Function Door open/close function The air mix actuator drives the motor based on the signals from the climate control unit and moves the air mi ...

Clutch Pipe And Hose Removal/Installation [C66 M R]
CAUTION: Do not allow clutch fluid to get on a painted surface. Clutch fluid contains properties which can dissolve the paint. If clutch fluid gets on a painted surface, wash it off with water immediately and wipe the area off completely. 1. Disconnect the negative battery cable. ...