1. Disconnect the negative battery cable..
2. Remove the inner garnish..
3. Remove the front door trim..
4. Insert a tape-wrapped flathead screwdriver into the service hole and remove hooks A in the direction of arrow (1).

5. Slide the service hole cover in the direction of the arrow (2) shown in the figure and remove tab B.
6. Disconnect the connector.
7. Remove nuts C.

8. Pull the power outer mirror in the direction of the arrow while remove clips D, pin E.
CAUTION:
If the clip D of the power outer mirror is detached, the power outer mirror may fall off and be damaged. When detaching clip D of the power outer mirror, hold the power outer mirror by hand during the servicing.
9. Install in the reverse order of removal.
Power Outer Mirror Inspection
Power Outer Mirror SystemStarter Removal/Installation [Skyactiv G 2.0]
WARNING:
Remove and install all parts when the engine is cold, otherwise they can
cause severe burns or serious injury.
When the battery cables are connected, touching the vehicle body with starter
terminal B will generate sparks. This can cause personal injury, fire, and d ...
Torque Box Removal [Panel Replacement]
Symbol Mark
Removal Procedure
1. Drill the 19 locations indicated by (A) shown in the figure.
NOTE:
When drilling the 19 locations indicated by (A) shown in the figure, do not
drill a hole all the way through or there could be a problem when installing
the new part.
2 ...
Break-In Period
No special break-in is necessary, but a few precautions in the first 1,000 km
(600 miles) may add to the performance, economy, and life of your Mazda.
• Do not race the engine.
• Do not maintain one constant speed,
either slow or fast, for a long period of time.
• Do not drive constantl ...