Mazda CX-5 Service & Repair Manual: Power Outer Mirror Inspection
Mirror Glass Adjustment
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Power outer mirror.
3. Apply battery positive voltage and connect the ground to the power outer mirror terminals and inspect the power outer mirror operation.
-
If the power outer mirror does not operate as indicated in the table, replace the power outer mirror.
|
Mirror operation direction |
Battery positive voltage connect terminal |
Ground connect terminal |
|
Up |
C |
F |
|
Down |
F |
C |
|
Left |
I |
F |
|
Right |
F |
I |
Heated Outer Mirror Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Power outer mirror.
d. Outer mirror glass.
3. Verify that the continuity between heated outer mirror connector terminals is as indicated in the table.
-
If not as indicated in the table, replace the power outer mirror..
Blind Spot Monitoring (BSM) Warning Indicator Light Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Power outer mirror.
d. Outer mirror glass.
3. Verify that the continuity between blind spot monitoring (BSM) warning indicator light connector terminals is as indicated in the table.
-
If not as indicated in the table, replace the power outer mirror..
Power Outer Mirror
Outline
The power outer mirror adjusts the outer mirror glass position up/down and
left/right using the up/down adjustment motor and, left/right adjustment motor.
The up/down adjustm ...
Power Outer Mirror Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the inner garnish..
3. Remove the front door trim..
4. Insert a tape-wrapped flathead screwdriver into the service hole and remove
hooks A ...
Other materials:
Shroud Panel Removal/Installation
CAUTION:
Since the servicing is performed with the hood open, secure the hood using
a piece of wood to prevent it from falling.
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Seal board upper.
b. Front bumper.
c. Front combination light.
d. Sh ...
Air Bag System Warning Alarm [Standard Deployment Control System]
Purpose
The air bag system warning alarm notifies the driver that a malfunction occurred
in the air bag system instead of the air bag system warning light.
Function
If a malfunction occurs in the air bag system while the air bag system warning
light cannot illuminate, the a ...
Operational Range
The system operates only when the driver is in the vehicle or within operational
range while the key is being carried.
NOTE
When the battery power is low, or in places where there are high-intensity
radio waves or noise, the operational range may become narrower or the system may
not operate ...
