Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Passenger Compartment Temperature Sensor Removal/Installation [Full Auto Air Conditioner]

Mazda CX-5 Service & Repair Manual / HVAC / A/C / Sensors, Switches, Relays / Passenger Compartment Temperature Sensor Removal/Installation [Full Auto Air Conditioner]

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Front scuff plate (driver-side).

b. Front side trim (driver-side).

c. Switch panel.

d. Decoration panel.

e. Shift lever knob (MTX).

f. Front console box.

g. Shift panel.

h. Upper panel.

i. Rear console.

j. Side wall.

k. Front console.

l. Hood release lever from the lower panel.

m. Lower panel (driver-side).

3. Remove the aspirator..


4. Remove the screw.

5. Disconnect the connector.


6. Remove the passenger compartment temperature sensor.

7. Install in the reverse order of removal.

Aspirator Removal Note

1. Remove the aspirator as shown in the figure.


Passenger Compartment Temperature Sensor Inspection [Full Auto Air Conditioner]
1. Measure the temperature around the passenger compartment temperature sensor and measure the resistance between passenger compartment temperature sensor terminals A and B. If the charact ...

Passenger Compartment Temperature Sensor [Full Auto Air Conditioner]
Purpose The passenger compartment temperature sensor detects the cabin temperature. Function The passenger compartment temperature sensor converts the detected temperature to an ...

Other materials:

Fresh Air Duct
Purpose, Function Conducts fresh air from outside the engine compartment. Increases air density by taking fresh air, which is cooler than the engine compartment, to enhance the charging efficiency, ensuring the combustion stability. Construction The fresh-air duct is i ...

Rear Upper Arm Removal/Installation [Awd]
WARNING: Verify that the crossmember is securely supported by a jack. If the rear crossmember falls off, it can cause serious injury or death, and damage to the vehicle. CAUTION: Performing the following procedures without first removing the rear ABS wheel-speed sensor ...

Propeller Shaft On Vehicle Inspection
Joint Area Excessive Play Inspection 1. Shake the universal joint by hand and verify that there is no excessive play. 2. If there is any excessive play, replace the propeller shaft.. Propeller Shaft Runout Inspection CAUTION: Do not rotate the propeller shaft using engine force wh ...

© 2016-2026 Copyright www.mcx5.org