Mazda CX-5 Service & Repair Manual: Manual Transaxle Shift Mechanism Removal/Installation [C66 M R]
1. Disconnect the negative battery cable..
2. Remove the shift lever using the following procedure:
a. Remove the upper panel..
b. Remove the shift lever knob.
c. Remove the shift panel..
d. Remove the side wall..
e. Remove the rear console..
f. Press the tabs on the control cable as shown in the figure and disconnect the shift lever from the control cable.
g. Disconnect the control cable end from shift lever as shown in the figure.
h. Disconnect the connector from shift lever as shown in the figure.
i. Remove the shift lever.
3. Remove the control cable using the following procedure:
a. Remove the air cleaner component. (ex: air cleaner, air hose).
b. Remove the battery component. (ex: battery, battery tray and PCM component).
c. Remove the control cable end from the MTX.
i. Pull the lock pin in the direction of the arrow shown in the figure and release the control cable end (MTX side) lock.
ii. Remove the control cable end from the MTX.
d. Press the tabs on the control cable and disconnect the control cable from the bracket.
e. Remove the fastening nut for the control cable.
f. Remove the fastening nuts for the grommet.
g. Remove the control cable.
4. Install in the reverse order of removal.
Manual Transaxle Removal/Installation [C66 M R]
Removal
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Remove the front under cover No.2..
4. Remove the front under cover No.1..
5. Remove the splash shield.. ...
Manual Transaxle [C66 M R]
Purpose, Function
The MTX converts the drive force (speed, torque, rotation direction) input
from the engine according to the shift lever operation inside the vehicle.
Construction
...
Other materials:
Side Wall Removal/Installation
1. Pull the side wall in the direction of the arrow in the order of (1), (2)
and remove it while detaching hooks A and clip B.
2. Pull the side wall in the direction of the arrow (3) and remove it while detaching
the guide C.
CAUTION:
If the hooks A and clip B is removed forceful ...
Seat
Outline
Front seat
A manual seat or power seat has been adopted on the driver's seat.
A seat warmer system has been adopted on the front seats. (with seat warmer
system)
A manual seat has been adopted on the front passenger's seat.
A side air bag module is ...
Starter [Skyactiv G 2.0]
Purpose, Function
The starter rotates the crankshaft via the ring gear and it serves as a trigger
to start the engine.
Construction
The starter is installed to the rear part of the engine on the left side.
The starter is a coaxial reduction type which can obt ...
