1. Park the vehicle on level ground.
2. Remove the front under cover No.2..
3. Remove the drain plug and gasket, and drain the manual transaxle oil.

4. Install a new gasket and the drain plug.
39—59 N·m {4.0—6.0 kgf·m, 29—43 ft·lbf}
5. Remove the oil level plug and gasket.

6. Add the specified manual transaxle oil through the oil level plug port.
API service GL-4
SAE 75W-80
1.65 L {1.74 US qt, 1.45 lmp qt}
7. Install a new gasket and the oil level plug.
39—59 N·m {4.0—6.0 kgf·m, 29—43 ft·lbf}
8. Install the front under cover No.2..
Manual Transaxle Oil Inspection [C66 M R]
Manual Transaxle Removal/Installation [C66 M R]Rear Door Garnish Removal/Installation
WARNING:
Using a utility knife with bare hands can cause injury. Always wear gloves
when using a utility knife.
Front
1. Using a tape-wrapped fastener remover, remove clips A in the direction of
arrow (1), (2) shown in the figure.
2. Remove the double-sided adhesive tape in the ...
Low Engine Coolant Temperature Indicator Light (Blue)/High Engine Coolant Temperature
Warning Light (Red)
Purpose
Low engine coolant temperature indicator light (blue)
The low engine coolant temperature indicator light (blue) notifies the driver
that the engine coolant temperature is low and vaporization of the fuel is difficult.
High engine coolant temperature warning light (red)
...
Ambient Temperature Sensor [Manual Air Conditioner]
Purpose
The ambient temperature sensor detects the ambient temperature.
Function
The ambient temperature sensor converts the detected temperature to an electric
signal.
Construction
A thermistor-type ambient temperature sensor has been adopted.
The ambient ...