Mazda CX-5 Service & Repair Manual: Fuel Pressure Sensor Inspection
Voltage Inspection
NOTE:
-
The fuel pressure sensor cannot be removed as a single unit. When replacing the fuel pressure sensor, replace it together with the fuel distributor as a single unit.
1. Connect the M-MDS to the DLC?2.
2. Switch the ignition ON (engine off or on).
3. Verify that the fuel pressure sensor output voltage (PID: FUEL_PRES) is within the specification..
-
If not as specified, replace the fuel distributor..
Specification
Returnless Fuel System
Purpose, Outline
Fuel evaporation in the fuel tank is reduced by adjusting the fuel amount
(fuel pressure) ejected from the fuel pump and preventing fuel warmed in the
engine compartment ...
Fuel Pressure Sensor
Purpose/Function
Detects the fuel pressure in the fuel distributor as basic information for
mainly determining the fuel injection amount.
Detects the fuel pressure in the fuel distri ...
Other materials:
Rear Bumper Reinforcement Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Rear splash shield.
b. Rear combination light.
c. Rear bumper.
3. Remove the hanger rubber in the direction of the arrow (1) shown in the figure.
4. Remove nuts.
CAUTION:
Removing the rear bumper ...
Power Window Subswitch Inspection
1. Disconnect the negative battery cable..
2. Remove the power window subswitch..
3. Verify that the continuity between the power window subswitch terminals is
as indicated in the table.
If not as indicated in the table, replace the power window subswitch.
...
Front Body Control Module (Fbcm)
Outline
Located at the front of the vehicle, the front body control module (FBCM)
performs numerous system controls for functions at the front of the vehicle.
Function
The front body control module (FBCM) controls the system based on the input/output
signals.
The fu ...
