Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Front Door Checker Removal/Installation

Mazda CX-5 Service & Repair Manual / Body / Doors/Lids & Hood/Trunk / Front Door Checker Removal/Installation

CAUTION:

1. Fully close the front door glass.

2. Disconnect the negative battery cable..

3. Remove the inner garnish..

4. Remove the front door trim..

5. Remove the front door speaker..

6. Remove bolt.


7. Remove nuts.


8. Pull out the front door checker from the front speaker installation hole.

9. Install in the reverse order of removal.

Doors And Liftgate
Outline Side impact bars built into the front and rear doors have been adopted. Door modules have been adopted on the front and rear doors. Structural view ...

Front Door Garnish Removal/Installation
WARNING: Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife. 1. Using a tape-wrapped fastener remover, remove clips A in the directi ...

Other materials:

Evaporator Temperature Sensor Inspection [Manual Air Conditioner]
NOTE: Inspect the evaporator temperature sensor when it is installed to the A/C unit. 1. Set the fan speed at MAX HI. 2. Set the temperature control at MAX COLD. 3. Set the RECIRCULATE mode. 4. Turn the A/C switch off. 5. Close all doors and windows. 6. Wait for 5 min. 7 ...

Event Data Recorder
Event Data Recorder This vehicle is equipped with an event data recorder (EDR). The main purpose of an EDR is to record, in certain crash or near crash-like situations, such as an air bag deployment or hitting a road obstacle, data that will assist in understanding how a vehicle's systems ...

Hood Latch Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the front bumper.. 3. Disconnect the hood latch switch connector.. 4. Verify that the continuity is as indicated in the table. NOTE: Inspect the continuity when the hood is open and closed. If the operation as i ...

© 2016-2026 Copyright www.mcx5.org