Mazda CX-5 Service & Repair Manual: Front Body Control Module (Fbcm) Removal/Installation
CAUTION:
-
If configuration is not performed when the front body control module (FBCM) is replaced with a new one, the vehicle specification information is not stored in the front body control module (FBCM) and the system will not operate normally.
-
When performing configuration, it is necessary to read the vehicle specification information from the front body control module (FBCM) before replacing it. Connect the M-MDS to the vehicle and perform vehicle identification before removing the front body control module (FBCM). The vehicle specification information is temporarily stored in the M-MDS.
NOTE:
-
The front body control module (FBCM) prior to replacement stores the vehicle specification information.
-
A new front body control module (FBCM) does not store any vehicle specification information.
-
If the vehicle specification information from the front body control module (FBCM) prior to replacement cannot be read, perform the configuration using As-Built data.
1. When replacing the front body control module (FBCM), perform the configuration..
2. Disconnect the negative battery cable..
3. Remove the fuse box cover..
4. Insert a tape-wrapped flathead screwdriver into the position shown in the figure.
5. Move the screwdriver in the direction of arrow (1) shown in the figure and lift the front body control module (FBCM) in the direction of arrow (2) to detach its tab from the fuse box.
6. Insert a tape-wrapped flathead screwdriver into the position shown in the figure.
7. Move the screwdriver in the direction of arrow (3) shown in the figure and lift the front body control module (FBCM) in the direction of arrow (4) to detach its tab from the fuse box.
8. Pull the front body control module (FBCM) in the direction of the arrow shown in the figure to remove it from the fuse box.
9. Disconnect the connectors shown in the figure.
10. Install in the reverse order of removal.
NOTE:
-
If configuration cannot be performed by reading/writing of the vehicle specification information, perform the configuration using As-Built information after replacing the front body control module (FBCM)..
Front Body Control Module (Fbcm) Inspection
1. Remove the fuse box cover..
2. Remove the front body control module (FBCM) from the fuse box..
3. Verify that the voltages of each of the terminals are as indicated in the
Terminal Voltage Ta ...
Main Relay Control [Skyactiv G 2.0]
Outline
Supplies power to each part by switching the main relay on/off at the optimal
timing according to the vehicle conditions.
Block Diagram
Operation
When the ignition ...
Other materials:
Sas Control Module Removal/Installation [Standard Deployment Control System]
WARNING:
Handling the SAS control module or air bag module improperly can accidentally
deploy the air bag modules and pre-tensioner seat belts, which may seriously
injure you. Read the air bag system service warnings and cautions before handling
the air bag module..
If the c ...
Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax
EL]
Purpose/Function
The turbine/input shaft speed sensor detects the rotation speed of the input
shaft (low clutch drum).
The output shaft speed sensor detects the rotation speed of the output shaft
(primary gear).
The turbine/input shaft speed sensor and output shaft speed ...
Head Restraints
Your vehicle is equipped with head restraints on all outboard seats and the rear
center seat. The head restraints are intended to help protect you and the passengers
from neck injury.
WARNING
Always drive with the head restraints installed when seats are being used
and make sure they are pro ...
