Mazda CX-5 Service & Repair Manual: Cooling System Cap
Purpose, Function
-
The cooling system cap maintains appropriate pressure in the engine coolant passage. In addition, cooling efficiency has been improved by increasing the engine coolant boiling point.
Construction
-
The cooling system cap is installed to the upper part of the radiator.
Operation
When engine coolant temperature is high
1. When the engine coolant temperature is high, the pressure in the engine coolant passage increases and the pressure valve is pressed and opened.
2. Engine coolant flows into the coolant reserve tank when the pressure valve is open.
When engine coolant temperature is low
1. When the engine coolant temperature is low, the pressure in the engine coolant passage decreases and the vacuum valve is opened.
2. Engine coolant in the coolant reserve tank flows into the engine coolant passage when the vacuum valve is open.
Cooling System Cap Inspection
WARNING:
Never remove the cooling system cap or loosen the radiator drain plug while
the engine is running, or when the engine and radiator are hot. Scalding engine
coolant and steam may ...
Cooling System Service Warnings
WARNING:
Never remove the cooling system cap or loosen the radiator drain plug while
the engine is running, or when the engine and radiator are hot. Scalding engine
coolant and steam may ...
Other materials:
Replace Electrical Battery
If the buttons on the transmitter are inoperable and the operation indicator
light does not flash, the battery may be dead.
Replace with a new battery before the transmitter becomes unusable.
CAUTION
● Make sure the battery is installed correctly.
Battery leakage could occur if it is no ...
Oil Seal (Control Valve Body) Replacement [Fw6 A EL, Fw6 Ax EL]
1. Disconnect the negative battery cable..
2. Remove the air cleaner component..
3. Disconnect the control valve body connector.
CAUTION:
Make sure that your hand does not touch the terminal as the connector terminal
could be damaged.
Water or foreign objects entering th ...
Start Stop Unit Configuration (Using As Built Data)
NOTE:
If the configuration is performed using As-Built data, the set value of the
personalization function is reset to the initial value (condition when shipped
from factory). Verify the set value with the customer and perform the personalization
function setting after performing th ...
