Mazda CX-5 Service & Repair Manual: Climate Control Unit Removal/Installation [Manual Air Conditioner]
Removal
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Shift lever knob (MTX).
b. Glove compartment.
c. Front console box.
d. Shift panel.
e. Upper panel.
f. Rear console.
g. Side wall.
h. Decoration panel.
i. Front console.
3. Press the tab down, then slide the wire off the link.
4. Remove the wire from the wire clamp.
5. Remove in the order indicated in the table.
|
1 |
Screw |
|
2 |
Connector |
|
3 |
Climate control unit |
6. Pull out the air mix wire and airflow mode wire from the dashboard.
Install
1. Pass each wire through the hole on the dashboard as shown in the figure.
2. Route each wire as shown in the figure.
3. Install in the order indicated in the table.
|
1 |
Connector |
|
2 |
Climate control unit |
|
3 |
Screw |
4. Connect each wire to links and install it to the wire clamps.
5. Verify that the dial operation is correct by fully turning each of the dials from one end to the other.
6. Install the following parts:
a. Front console.
b. Decoration panel.
c. Side wall.
d. Rear console.
e. Upper panel.
f. Shift panel.
g. Front console box.
h. Glove compartment.
i. Shift lever knob (MTX).
7. Connect the negative battery cable..
Climate Control Unit Removal/Installation [Full Auto Air Conditioner]
NOTE:
The climate control unit prior to replacement stores the vehicle specification
information.
The new climate control unit does not store any vehicle specification information.
...
Climate Control Unit [Manual Air Conditioner]
Purpose
The climate control unit performs air conditioning according to the operation
by the users and the driving conditions of the vehicle.
Function
The climate control unit d ...
Other materials:
Front Combination Light Disassembly/Assembly
1. Disassemble in the order shown in the figure.
Halogen type
1
Short cord
(See Short Cord Removal Note.)
2
Parking/Front turn light bulb
(See PARKING/FRONT TURN LIGHT BULB REMOVAL/INSTALLATION.)
3
Headlight ...
Differential Oil Temperature Sensor
Purpose, Function
The differential oil temperature sensor detects the rear differential oil
temperature based on the resistance of the thermistor, and inputs it to the
AWD CM.
Construction
The differential oil temperature sensor is installed in the rear differential
carr ...
Engine Oil Replacement
WARNING:
Hot engines and engine oil can cause severe burns. Turn off the engine and
wait until it and the engine oil have cooled.
A vehicle that is lifted but not securely supported on safety stands is dangerous.
It can slip or fall, causing death or serious injury. Never work ...
