The ignition must be switched ON.
Rear WindowWiper

Turn the wiper on by turning the rear wiper/washer switch.

Rear WindowWasher
To spray washer fluid, turn the rear wiper/ washer switch to the
position. After the switch is released,
the washer will stop.
If the washer does not work, inspect the fluid level . If it's normal and the washer still does not work, consult an Authorized Mazda Dealer.
Windshield Wipers and Washer
Rear Window DefrosterTire Pressure Monitoring System Initialization Procedure
Perform the tire pressure monitoring system initialization when the following
operations have been performed:
Tire pressures have been adjusted
Tires or wheels have been replaced
Tires have been rotated
DSC HU/CM replaced
DSC HU/CM ...
Air Fuel Ratio (A/F) Sensor Heater Control [Skyactiv G 2.0]
Outline
Based on the control of the A/F sensor heater, a stabilized oxygen concentration
is detected even at low exhaust temperatures, and feedback control of fuel injection
even at cold engine start is made possible for improved cold temperature exhaust
emission performance.
...
Brake Fluid Level Sensor Inspection
1. Disconnect the brake fluid level sensor connector from the master cylinder.
2. Inspect for continuity according to fluid level between the brake fluid level
sensor terminals.
If not as indicated in the table, replace the reserve tank..
...