Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Water Pump

Purpose, Function

Construction

Operation

1. The water pump pulley rotates by obtaining drive force from the engine via the drive belt.

2. The impeller with the water pump pulley and shaft connected rotates to pump engine coolant.

Water Pump Removal/Installation
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may ...

Cooling Fan Relay
Purpose, Function The cooling fan relay operates by receiving the signal from the PCM to supply power to the cooling fan motor. Construction The cooling fan relay is installed o ...

Other materials:

Barometric Pressure (Baro) Sensor Inspection
Voltage Inspection NOTE: Because the BARO sensor is integrated in the PCM, replacing the BARO sensor includes replacement of the PCM. 1. Connect the M-MDS to the DLC?2. 2. Switch the ignition ON (engine off or on). 3. Verify that the BARO sensor output voltage (PID: BARO) is wi ...

Front Door Trim Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the inner garnish.. 3. Insert a tape-wrapped flathead screwdriver in the position indicated by the arrow (1) in the figure and remove the inner handle cover while detach tabs A, pin B. 4. Remove the screw C. 5. Remove the cover ...

Negative Battery Cable Disconnection/Connection [Skyactiv G 2.0]
WARNING: Before removing the SRS air bag system-related parts, always disconnect the negative battery cable and wait for 1 min. or more to allow the back-up power supply to deplete its stored power.. Required procedure after negative battery cable disconnection/connection ...

© 2016-2024 Copyright www.mcx5.org