Mazda CX-5 Service & Repair Manual: Positive Crankcase Ventilation (PCV) Valve
Purpose, Function
-
Prevents release of blow-by gas (unburnt gas) into the atmosphere.
-
The PCV valve is open/closed by the intake manifold vacuum.
Construction
-
The PCV valve is installed to the oil separator.
-
The PCV valve consists of a spring and valve.
Operation
-
When the valve is pulled by the intake manifold vacuum, blow-by gas flows to the intake manifold.
-
Blow-by gas flow amount is adjusted by the spring according to the intake manifold vacuum.
Positive Crankcase Ventilation (PCV) Valve Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the intake manifold..
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
1
...
Purge Solenoid Valve Inspection
Airflow Inspection
1. Disconnect the negative battery cable..
2. Remove the purge solenoid valve..
3. Inspect airflow between the ports under the following conditions.
...
Other materials:
Refrigerant Pressure Sensor [Full Auto Air Conditioner]
Purpose
The refrigerant pressure sensor detects the refrigerant pressure in the refrigerant
cycle.
Function
The refrigerant pressure sensor converts the detected refrigerant pressure
to an electric signal and sends it to the PCM.
Construction
The refriger ...
Keyless Beeper Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the cowl grille..
3. Disconnect the connector.
4. Pull the keyless buzzer in the direction of the arrow (2) shown in the figure
while pressing the keyless buzzer tab in the direction of the arrow (1) shown in
the figure, detach the k ...
Rear Stabilizer Removal/Installation [2 Wd]
WARNING:
Verify that the rear crossmember is securely supported by a jack. If the
rear crossmember falls off, it can cause serious injury or death, and damage
to the vehicle.
CAUTION:
Performing the following procedures without first removing the rear ABS wheel-spee ...
