Mazda CX-5 Service & Repair Manual: Oil Pump [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
-
The oil pump generates hydraulic pressure in the oil line of the automatic transaxle together with supplying lubrication to powertrain related parts.
Construction
-
The oil pump has adopted a gear type with built-in outer and inner rotors.
-
The inner rotor engages with the torque converter and rotates in conjunction with the rotation of the torque converter.
Operation
-
When the inner rotor in the oil pump rotates, vacuum is generated in the outer rotor. As a result, ATF in the oil pan is suctioned to the oil pump. Further rotation of the inner rotor causes the inner rotor blades to push the ATF and discharge it from the oil pump.
-
The ATF discharge flow amount increases or decreases in proportion to the rotation speed of the inner rotor.
Oil Pump Removal/Installation [Skyactiv G 2.0]
WARNING:
Hot engines and engine oil can cause severe burns. Turn off the engine and
wait until it and the engine oil have cooled.
A vehicle that is lifted but not securely supported ...
Oil Pump [Skyactiv G 2.0]
Outline
The oil pump has a mechanism for feedback control of oil pressure. As a result,
an oil pressure increase of more than the set pressure is suppressed and oil
pump drive resistance ...
Other materials:
Operating Tips for Audio System
WARNING
Always adjust the audio while the vehicle is stopped:
Do not adjust the audio control switches while driving the vehicle.
Adjusting the audio while driving the vehicle is dangerous as it could distract
your attention from the vehicle operation which could lead to a serious accident.
Ev ...
Shift Control Module Removal/Installation [C66 M R]
Removal
1. Shift the shift lever to the neutral position.
2. Remove the plug hole plate..
3. Disconnect the negative battery cable..
4. Remove the air cleaner and air hose as a single unit..
5. Remove the battery and battery tray..
6. Disconnect the control cable from the transaxle.
a. ...
Purge Solenoid Valve Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Remove the air cleaner and air hose as a single unit..
4. Disconnect the high pressure fuel pump connector.
5. Disconnect the harness clip as shown in the figure.
6. Remove in the order indicated in the table ...
