Chevrolet Spark manuals

Mazda CX-5 Owners Manual: Engine Oil

NOTE

Changing the engine oil should be performed by an Authorized Mazda Dealer.

Refer to Introduction  for owner's responsibility in protecting your investment.

Recommended Oil

U.S.A. and CANADA

0W-20 full synthetic recommended:

Mazda Genuine Oil is used in your Mazda vehicle and is the recommended 0W-20 lubricant. Mazda Genuine 0W-20 Oil is required to achieve optimum fuel economy.

Recommended viscosity: SAE 0W-20 For maintenance service, Mazda recommends Mazda Genuine Parts and Castrol® (U.S.A. only).



Only use SAE 0W-20 oil with the American Petroleum Institute (API) symbol and ILSAC GF-5.

Oil with this trademark symbol conforms to the current engine and emission system protection standards and fuel economy requirements of the International Lubricant Standardization and Approval Committee (ILSAC), comprised of U.S.

and Japanese automobile manufacturers.



Except U.S.A. and CANADA

Use SAE 5W-30 engine oil.

Oil container labels provide important information.

A chief contribution this type of oil makes to fuel economy is reducing the amount of fuel necessary to overcome engine friction.

For maintenance service, Mazda recommends Mazda Genuine Parts and Castrol® (Mexico only).



(Mexico

)

Use SAE 5W-30 engine oil. If SAE 5W- 30 engine oil is not available, use SAE 5W-20 engine oil.

The quality designation SM, or ILSAC must be on the label.



Inspecting Engine Oil Level

1. Be sure the vehicle is on a level surface.

2. Warm up the engine to normal operating temperature.

3. Turn it off and wait at least 5 minutes for the oil to return to the oil pan.

4. Pull out the dipstick, wipe it clean, and reinsert it fully.


5. Pull it out again and examine the level.

The level is normal if it is between Low and Full.

If it is near or below Low, add enough oil to bring the level to Full.

CAUTION

Do not add engine oil over Full. This may cause engine damage.

6. Make sure the O-ring on the dipstick is positioned properly before reinserting the dipstick.

7. Reinsert the dipstick fully.

Engine Compartment Overview
...

Engine Coolant
Inspecting Coolant Level WARNING Do not use a match or live flame in the engine compartment. DO NOT ADD COOLANT WHEN THE ENGINE IS HOT: A hot engine is dangerous. If the engine has been running, ...

Other materials:

Magnetic Clutch Disassembly/Assembly [Manual Air Conditioner]
1. Disassemble in the order indicated in the table. 1 Bolt (See Bolt Removal/Installation Note.) 2 Pressure plate 3 Shim (See Shim Installation Note.) 4 Snap ring (See Snap Ring ...

Side Sill Panel Removal [Panel Replacement]
Symbol Mark Removal Procedure Side sill (front side) 1. Rough cut the 2 locations indicated by (A) shown in the figure. 2. Drill the 18 locations indicated by (B) shown in the figure. 3. Remove the cabin side outer frame (outer side sill). Side sill (component) 1. Rough cut the 3 l ...

Transfer Oil Seal Replacement [Fw6 Ax EL]
Transfer oil seal (LH) 1. Drain the transfer oil.. 2. Remove the transfer from the vehicle.. 3. Insert a tape-wrapped flathead screwdriver into the lip area of the oil seal (LH) as shown in the figure and remove the oil seal (LH). 4. Using the SST and a hammer, tap the new seal into pla ...

© 2016-2024 Copyright www.mcx5.org