Mazda CX-5 Service & Repair Manual: Transfer Oil Seal Replacement [Fw6 Ax EL]
Transfer oil seal (LH)
1. Drain the transfer oil..
2. Remove the transfer from the vehicle..
3. Insert a tape-wrapped flathead screwdriver into the lip area of the oil seal (LH) as shown in the figure and remove the oil seal (LH).
4. Using the SST
and a hammer, tap the new seal into place.
5. Apply the lip of the oil seal with transfer oil.
6. Install the transfer to the vehicle..
7. Add the specified amount and type of oil..
Transfer oil seal (RH) No.1
1. Remove the front drive shaft (RH)..
2. Insert a flathead screwdriver into the notch of the transfer and remove the oil seal (RH) No.1.
3. Using the SST
and a hammer, tap the new seal into place.
4. Coat the lip of the oil seal with transfer oil.
5. Install the front drive shaft (RH)..
Transfer oil seal (RH) No.2
1. Drain the transfer oil..
2. Remove the front drive shaft (RH)..
3. Remove the transfer oil seal (RH) No.1..
4. Insert a tape-wrapped flathead screwdriver into the lip area of the oil seal (RH) No.2 as shown in the figure and remove the oil seal (RH) No.2.
5. Using the SST
and a hammer, tap the new seal into place.
6. Apply the lip of the oil seal with transfer oil.
7. Install the transfer oil seal (RH) No.1..
8. Install the front drive shaft (RH)..
9. Add the specified amount and type of oil..
Transfer oil seal (RH) No.3
1. Drain the transfer oil..
2. Remove the front drive shaft (RH)..
3. Remove the transfer oil seal (RH) No.1..
4. Remove the oil seals using a tape-wrapped flathead screwdriver.
5. Using the SST
and a hammer, tap the new seal into place.
6. Apply the lip of the oil seal with transfer oil.
7. Install the transfer oil seal (RH) No.1..
8. Install the front drive shaft (RH)..
9. Add the specified amount and type of oil..
Transfer Oil Replacement [Fw6 Ax EL]
1. Remove the front under cover No.2..
2. Remove the drain plug with the washer.
3. Drain the oil into a suitable container.
4. Tighten the drain plug with a new washer.
Tightening ...
Transfer Removal/Installation [Fw6 Ax EL]
CAUTION:
Performing the following procedures without first removing the front ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before ...
Other materials:
Oil Pressure Switch Inspection
1. Switch the ignition ON (engine off) and verify that the oil pressure warning
light is illuminated.
2. Start the engine and verify that the oil pressure warning light turns off.
If the oil pressure warning light is not illuminated or remains illuminated,
inspect the wiring harness ...
Steering Wheel And Column Removal/Installation
WARNING:
Handling the air bag module improperly can accidentally operate (deploy)
the air bag module, which may seriously injure you. Read the service warnings
and cautions before handling the air bag module..
The steering column (EPS motor) temperature increases directly after ...
Cargo Compartment Light
Purpose
The cargo compartment light illuminates the cargo room interior when the
liftgate is opened.
Function
When the liftgate is opened, illuminates by the cargo room light switch turning
on.
Construction
The cargo room light is installed to the trunk side tr ...
