Mazda CX-5 Service & Repair Manual: Wiper/Washer System Personalization
-
A customize function has been adopted which switches the auto wiper system between operable/inoperable.
Using Mazda Modular Diagnostic System (M-MDS)
-
The auto wiper function can be enabled or disabled using the Mazda Modular Diagnostic System (M-MDS). Refer to the Workshop Manual for the customize function setting procedure.
|
Mazda Modular Diagnostic System (M-MDS) display |
Function |
Initial setting |
Setting contents |
Control module |
|
Rain Sensing Wipers |
Auto wiper system can be set to operable or inoperable. |
On |
Not Adopted / Off (Intermittent) / On (Rain Sensing) |
Rear body control module (RBCM) |
Using Audio Unit (With Color LCD)
-
The user can enable or disable the auto wiper function by operating the audio unit display. Refer to the Workshop Manual for the detailed customize function setting procedure.
|
Audio unit display |
Function |
Initial setting |
Setting contents |
Control module |
|
Wipers |
Auto wiper system can be set to operable or inoperable. |
On (Rain Sensing) |
On (Rain Sensing) / Off (Intermittent) |
Rear body control module (RBCM) |
Wiper/Washer System
Outline
The following wiper/washer system has been adopted.
Windshield wiper system
Rear wiper system
Auto wiper system (with auto wiper system)
Wa ...
Wiper/Washer System Personalization Features Setting Procedure
Using M-MDS
The auto wiper function can be enabled or disabled using the M-MDS. Refer
to the control system personalization features setting..
Using Audio Unit (With Color LCD)
...
Other materials:
Sail Garnish Removal/Installation
1. Open the front door.
2. Affix protective tape to the position shown in the figure.
3. Insert a tape-wrapped flathead screwdriver into the shown in the figure and
remove the clip A in the direction of arrow (1).
4. Pull the sail garnish in the direction of the arrow (2) and remove it w ...
Front Sash Molding Removal
WARNING:
Using a utility knife with bare hands can cause injury. Always wear gloves
when using a utility knife.
1. Using a utility knife, carefully remove the double-sided adhesive tape in
the locations shown below.
CAUTION:
When removing the double-sided adhesive tape, ...
Ion Sensor
Purpose/Function
Detects ion generation in the combustion chamber for detecting pre-ignition.
Detects ions which occur due to fuel combustion as current by applying bias
voltage to the spark plug, which is amplified in the ignition coil internal
circuit and input to the PCM.
...
