Mazda CX-5 Service & Repair Manual: Windshield Wiper Motor Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Windshield wiper arm and blade.
b. Cowl grille.
Windshield Wiper Motor Inspection
1. Apply battery positive voltage and connect the ground to the windshield wiper motor terminals as indicated in the table below and verify the operation condition.
|
B+ |
Ground |
Windshield wiper motor operation status |
|
A |
D |
LO |
|
B |
D |
HI |
-
If not as indicated in the table, replace the windshield wiper motor..
Auto-stop Operation Inspection
1. Connect the battery voltage to windshield wiper motor terminal A, connect the ground to motor terminal D, and operate the windshield wiper motor at low speed.
2. Disconnect the battery voltage from terminal A during windshield wiper LO operation, and stop the windshield wiper motor halfway.
3. Connect windshield wiper motor terminals A and E using a jumper wire.
4. Connect the battery positive voltage to windshield wiper motor terminal C.
5. After the windshield wiper motor auto-stop operation, verify that it stops at the park position.
-
If there is any malfunction, replace the windshield wiper motor..
Windshield Wiper Motor And Link Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Windshield wiper arm and blade.
b. Cowl grille.
CAUTION:
Always affix protective tape to the windshield end ...
Windshield Wiper System
Outline
Equipped with continuous (low/high), auto-stop, one-touch wiper, intermittent
wiper (without auto wiper system), auto wiper (with auto wiper system), and
synchronized washer and w ...
Other materials:
Clutch Pedal Position Switch Removal/Installation [C66 M R]
1. Disconnect the negative battery cable..
2. Disconnect the clutch pedal position switch connector.
3. Rotate the clutch pedal position switch 45° counterclockwise.
4. Remove the clutch pedal position switch from the clutch pedal.
5. Insert a new clutch pedal position switch into t ...
Low Engine Coolant Temperature Indicator Light (Blue)/High Engine Coolant Temperature
Warning Light (Red)
Purpose
Low engine coolant temperature indicator light (blue)
The low engine coolant temperature indicator light (blue) notifies the driver
that the engine coolant temperature is low and vaporization of the fuel is difficult.
High engine coolant temperature warning light (red)
...
Rear Washer Nozzle Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the liftgate upper trim..
3. Remove the rear spoiler..
4. Disconnect the rear washer hose from the rear washer nozzle..
5. While pressing tabs of the rear washer nozzle in the direction of the arrows
(1) shown in the figure, pull the rea ...
