Mazda CX-5 Service & Repair Manual: Windshield Wiper Arm And Blade Adjustment
1. Switch the ignition ON (engine off or on).
2. Operate the windshield wiper at low speed.
3. Verify that the windshield wiper operates at low speed and stop the windshield wiper.
4. Verify that the windshield wiper stops at the auto-stop position.
5. Remove the windshield wiper arm and blade..
6. Install the windshield wiper arm to the serrated connecting part, adjust the windshield wiper blade so that its end is aligned with the hollowed mark in the ceramic coating while sliding the windshield wiper arm onto the grooves of the serrated connecting part one by one, and temporarily tighten the nut.
7. If the hollowed mark in the ceramic coating cannot be located, adjust the windshield wiper blade end to the area shown in the figure.
NOTE:
-
If the windshield wiper arm and blade is not installed to the position shown in the figure, repeat the adjustment procedure.
8. After adjusting the windshield wiper arm and blade, tighten the nut completely..
Rear Wiper System
Outline
Equipped with continuous, auto-stop, intermittent wiper, and synchronized
washer and wiper operation.
The front body control module (FBCM) performs rear wiper and washer syst ...
Windshield Wiper Arm And Blade Removal/Installation
Windshield Wiper Arm
1. Open the hood.
CAUTION:
If excessive force is applied when removing the cap, tabs could break. Carefully
remove the cap.
2. Insert a tape-wrapped precision ...
Other materials:
Knee Bolster Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Driver-side front scuff plate.
b. Driver-side front side trim.
c. Switch panel.
d. Decoration panel.
e. Shift lever knob (MTX).
f. Front console box.
g. Shift panel.
h. Upper panel.
i. Rear console.
j. ...
Front Console Box Removal/Installation
NOTE:
Affix protective tape to the position shown in the figure.
1. Insert a tape-wrapped flathead screwdriver in the position indicated by the
arrow in the figure and detach clips A.
2. Pull the front console box in the direction of the arrow (2) and remove it
while d ...
Heater Core
Purpose
The heater core heats passing air.
Function
A portion of the engine coolant is taken into the heater core to heat the
air passing through the heater core.
Construction
The heater core consists of a tube which passes engine coolant, and the heat
ra ...
