Mazda CX-5 Service & Repair Manual: Windshield Removal
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Windshield wiper arm and blade.
b. Cowl grille.
c. Rain sensor (with auto light/wiper system).
d. Auto-dimming mirror (with auto-dimming mirror).
e. Rearview mirror (without auto-dimming mirror).
f. A-pillar trim.
g. Sunvisor.
h. Front map light.
i. Assist handle.
3. Set the headliner out of the way.
4. Apply protective tape along the edge of the body.
NOTE:
-
Overlap and adhere the protective tape to the corners to prevent damage.
5. Remove the windshield molding by pulling it outward.
NOTE:
-
If the windshield molding is difficult to remove, warm the windshield molding using a hot air blower.
-
The windshield molding is a replacement part.
Not Reusing Windshield
WARNING:
-
Using piano wire with bare hands can cause injury. Always wear gloves when using piano wire.
NOTE:
-
If it is difficult to cut sealant, use piano wire and follow the procedure under “Reusing Windshield”.
1. Cut out the sealant all around the glass using a sealant remover.
2. Remove the windshield.
Reusing Windshield
WARNING:
-
Using piano wire with bare hands can cause injury. Always wear gloves when using piano wire.
CAUTION:
-
Because the lens for rainfall/illumination level detection is integrated with the windshield, the auto light/wiper systems may not operate correctly if the lens is damaged. When removing the windshield, be careful not to damage the lens. If the lens is damaged, replace the windshield.
NOTE:
-
Before removing the windshield from the body, mark the position of the windshield by affixing tape to the windshield and body panel.
1. Avoiding the pin on the inside of the vehicle, insert piano wire which has been cut to sufficient length.
2. Wind each end of piano wire around a bar.
NOTE:
-
Use a long sawing action to spread the work over the whole length of piano wire to prevent it from breaking due to localized heating.
3. Secure one end of piano wire, and while pulling the other end, cut the sealant around the windshield.
4. Pinch the pin from the inside of the vehicle and detach it.
5. Remove the windshield.
6. If the pin is damaged, remove the pin.
NOTE:
-
Before removing the pin from the windshield glass, place an alignment mark on the windshield.
Windshield Installation
WARNING:
Using a utility knife with bare hands can cause injury. Always wear gloves
when using a utility knife.
CAUTION:
If a door is opened or closed when all the window glas ...
Horn
...
Other materials:
Discharge Headlight System
Outline
The discharge headlight system utilizes a gas discharge type light to emit
a white light resembling sunlight over a wide area. Also, use of the gas discharge
type light realizes high efficiency, low power consumption lighting.
Structural View
System Wiring Diagram
...
Positive Crankcase Ventilation (PCV) Valve Inspection
Airflow Inspection
1. Disconnect the section (A) of ventilation hose shown in the figure.
2. Start the engine and verify that vacuum is applied to the end of the disconnected
ventilation hose while the engine is idling.
If vacuum is not applied to the ventilation hose, perform the p ...
Shift Point Control (Automatic Shift Control) [Fw6 A EL, Fw6 Ax EL]
Outline
The TCM implements auto shift control according to the vehicle speed and
accelerator pedal depression amount while in D position.
When the vehicle is stopped with the selector lever is in the D position
and the brake pedal depressed, the neutral idle control is performed ...
