Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Wheel Hub, Steering Knuckle Inspection

Mazda CX-5 Service & Repair Manual / Suspension / Front Suspension / Wheel Hub, Steering Knuckle Inspection

Wheel Bearing Excessive Play Inspection

1. Install the magnetic base and dial gauge as shown in the figure and measure the wheel bearing axial excessive play.


Front Wheel Hub Bolt Replacement
1. Remove the brake calliper component from the steering knuckle and suspend it out of the way using a cable. 2. Remove the disc plate. 3. Remove the wheel hub bolt using the SST as shown in the ...

Wheel Hub, Steering Knuckle Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Befo ...

Other materials:

Headliner Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Sunroof seaming welt (with sunroof system). b. A-pillar trim. c. Front map light. d. Sunvisor. e. Front scuff plate. f. Rear scuff plate. g. B-pillar lower trim. h. Adjust anchor cover. i. Upper anchor i ...

Pressure Control Valve Inspection [Skyactiv G 2.0]
1. Remove the pressure control valve assembly.. CAUTION: Do not apply a pressure 36 kPa {0.37 kgf/cm2, 5.2 psi} or more. Doing so will damage the pressure control valve and evaporative hose. 2. Apply a pressure of 36 kPa {0.37 kgf/cm2, 5.2 psi} to port A. 3. Verify that ther ...

Auto Dimming Mirror Inspection
1. Measure the voltage at each terminal. If the voltage is not as specified in the Terminal Voltage Table (Reference), inspect the parts under “Inspection item (s)” and related wiring harnesses. If the system does not work properly even though the inspection items or ...

© 2016-2026 Copyright www.mcx5.org