Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Wheel Hub Component Inspection

Mazda CX-5 Service & Repair Manual / Suspension / General / Wheel Hub Component Inspection

Wheel Bearing Excessive Play Inspection

1. Install the magnetic base and dial gauge as shown in the figure and measure the wheel bearing axial excessive play.


Suspension Features
Improved rigidity and handling stability A strut type front suspension adopted E-type multi-link rear suspension adopted For the front ...

Wheel Hub Component Removal/Installation [2 Wd]
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Befo ...

Other materials:

Heater Hose Removal/Installation
With Water Temperature Sensor 1. Remove the battery.. 2. Drain the engine coolant.. 3. Remove the insulator. 4. Remove the clips and remove the heater hose. 5. Remove the heater hose. 6. Install in the reverse order of the removal. 7. Inspect for engine coolant leaka ...

Coupler Component Removal/Installation [Fw6 A EL, Fw6 Ax EL]
WARNING: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool. Always wear protective eye wear when using the air compressor. If the air compressor is used, any particles of dirt or soiling could spatter and get into the eyes. ...

Front Door Trim Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the inner garnish.. 3. Insert a tape-wrapped flathead screwdriver in the position indicated by the arrow (1) in the figure and remove the inner handle cover while detach tabs A, pin B. 4. Remove the screw C. 5. Remove the cover ...

© 2016-2022 Copyright www.mcx5.org