Mazda CX-5 Service & Repair Manual: Wheel, Column

Steering Gear And Linkage Removal/Installation

CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before ...

Steering Column And Shaft

Purpose/Function The steering input force, generated when the driver operates the steering wheel, is transmitted to the steering gear. Construction The steering column and shaft ...

Other materials:

Fuel Gauge Sender Unit Removal/Installation [Awd]
WARNING: Always keep sparks and flames away from fuel when servicing the fuel system. Fuel can be easily ignited which could cause serious injury or death, and damage to equipment. Fuel line spills and leakage from the pressurized fuel system are dangerous. Fuel can ignite a ...

Taillight Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure. 3. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, pull out the service hole cover from the liftgate, a ...

Back Up Light Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the front under cover No.2.. 3. Remove the back-up light switch.. 4. Verify that the continuity between the back-up light switch terminals is as indicated in the table. If not as indicated in the table, replace the back-up ...