Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Wheel Balance Adjustment (Aluminum Alloy Wheel)

Mazda CX-5 Service & Repair Manual / Suspension / Wheels, Tires / Wheel Balance Adjustment (Aluminum Alloy Wheel)

CAUTION:

Adhesive-type Balance Weight (Outer)

1. Remove the old balance weight from the wheel.

2. Remove the double-sided adhesive tape remaining on the wheel, then clean and degrease the bonding area.

3. Set the wheel on a wheel balancer, measure the amount of unbalance and the position with the mode set for knock-type balance weight.

4. Multiply the amount of unbalance by 1.6

to obtain the balance weight value.

5. Select a balance weight closest to the weight value and attach the balance weight on the position (outer) indicated by the wheel balancer.


NOTE:

CAUTION:

6. If attaching two balance weights, position them so that each is on either side of the position indicated by the wheel balancer.


CAUTION:

Knock-type Balance Weight (Inner)

1. Measure the amount of unbalance with a wheel balancer.

2. Attach a weight corresponding to the measured weight value on the position (inner) indicated by the wheel balancer.


CAUTION:

Remaining Amount of Unbalance Confirmation

1. After installing the outer and inner balance weights, operate the wheel balancer again.

2. Confirm that the remaining unbalance does not exceed the following on either side.

Specifications


Outer (Adhesive-type)

Inner (Knock-type)

17 inch wheel

13 g {0.46 oz}

8 g {0.28 oz}

19 inch wheel

12 g {0.42 oz}

7 g {0.25 oz}


Wheel Apron Component Removal [Panel Replacement]
Symbol Mark Removal Procedure 1. Drill the 14 locations indicated by (A) from the front wheel housing side shown in the figure. 2. Drill the 11 locations indicated by (B) shown in the figure ...

Wheels And Tires
Outline An adhesive-type balance weights has been adopted to the outer side of the aluminum alloy wheels. Due to this, a stylish wheel design is realized. In consideration of the e ...

Other materials:

Rear Door Speaker Inspection
1. Disconnect the negative battery cable.. 2. Remove the rear door trim.. 3. Disconnect the rear door speaker connector.. 4. Verify that the resistance between the rear door speaker terminals is as indicated in the table. If not as indicated in the table, replace the rear door sp ...

Car Navigation System
Outline The car-navigation system displays point-of-origin and road guidance maps via the audio unit display and provides guidance and information to the desired point of destination. NOTE: For the car-navigation system operation, refer to the owner's manual. ...

Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The turbine/input shaft speed sensor detects the rotation speed of the input shaft (low clutch drum). The output shaft speed sensor detects the rotation speed of the output shaft (primary gear). The turbine/input shaft speed sensor and output shaft speed ...

© 2016-2022 Copyright www.mcx5.org