Mazda CX-5 Service & Repair Manual: Washers

Wiper And Washer Switch Removal/Installation

1. Switch the ignition ON (engine off or on). 2. Open the driver's door. 3. Switch the ignition OFF. 4. Disconnect the negative battery cable.. 5. Remove the column cover.. 6. Rotate the ...

Rear Washer Hose Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the front over fender.. 3. Remove the mudguard (RH).. 4. Disconnect the rear washer hose A from the washer motor. 5. Remove the rear washer ...

Other materials:

Steering Angle Sensor Inspection
1. Remove the column cover.. 2. Connect the plus (+) end of a tester to steering angle sensor terminal A and the minus (-) end of the tester to terminal B (GND). 3. Switch the ignition ON (engine off or on). 4. Turn the steering wheel to the left and right. 5. Verify that the voltage f ...

Passenger Compartment Temperature Sensor Removal/Installation [Full Auto Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate (driver-side). b. Front side trim (driver-side). c. Switch panel. d. Decoration panel. e. Shift lever knob (MTX). f. Front console box. g. Shift panel. h. Upper panel. i. Rear console. ...

Air Mix Actuator [Full Auto Air Conditioner]
Purpose The air mix actuator moves the air mix door in the A/C unit to adjust the temperature of the air blown from the air vent. Function Door open/close function The air mix actuator drives the motor based on the signals from the climate control unit and moves the air mi ...