Mazda CX-5 Service & Repair Manual: Valvetrain, Cylinder Head
- Camshaft Position (CMP) Sensor Inspection
- Camshaft Position (CMP) Sensor Removal/Installation
- Camshaft Position (CMP) Sensor
- Camshaft
- Cylinder Head Cover
- Cylinder Head Gasket Replacement
- Cylinder Head Gasket
- Cylinder Head
- Hydraulic Lash Adjuster (Hla) Inspection
- Hydraulic Lash Adjuster (Hla) Removal/Installation
- Hydraulic Lash Adjuster, Rocker Arm
- Valve, Valve Spring, Valve Seal, Valve Guide
Piston, Piston Ring, Piston Pin
Purpose, Function
Piston
The piston in the cylinder of the cylinder block moves reciprocally by the
pressure received when the air-fuel mixture combusts.
Piston ring
The piston ...
Camshaft Position (CMP) Sensor Inspection
Intake CMP Sensor
Visual inspection
CAUTION:
When replacing the CMP sensor, make sure there is no foreign material on
it such as metal shavings. If it is installed with foreign material, ...
Other materials:
Tie Rod End Replacement
1. Remove the snap pin.
2. Loosen the tie-rod end locknut.
3. Detach the tie-rod end from the steering knuckle using the SST.
4. Remove the tie-rod end locknut.
5. Place alignment marks as shown in the figure for proper installation.
6. Remove the tie-rod end.
7. Align th ...
ABS Wheel Speed Sensor And ABS Sensor Rotor
Purpose/Function
The ABS wheel-speed sensor and ABS sensor rotor detect the rotation condition
of each wheel and transmit this information to the DSC HU/CM.
The signal from the ABS wheel-speed sensor is the primary signal that the
DSC HU/CM uses when carrying out control.
...
Front Door Speaker Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Inner garnish.
b. Front door trim.
3. Disconnect the front door speaker connector..
4. Verify that the resistance and continuity between the front door speaker terminals
is as indicated in the table.
...
