Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Vacuum Pump Inspection

Mazda CX-5 Service & Repair Manual / Brakes / General / Vacuum Pump Inspection

1. Pinch open the clamp using pliers and disconnect the vacuum hose from the vacuum pump..

2. Install the vacuum gauge as shown in the figure, then check the vacuum.


3. Warn up the engine.

Vacuum pump vacuum specification (reference value)

Measurement condition

Specification

Engine speed

Change in vacuum amount

Period of time change in vacuum amount condition met

While idling (520—700 rpm (reference value))

From 60 kPa {450 mmHg, 18 inHg} to 67 kPa {503 mmHg, 20 inHg}

8 s or less


Vacuum pump maximum vacuum specification (reference value)

Measurement condition

Specification

While idling (no time designation)

93.3 kPa {700 mmHg, 27.6 inHg} or more


4. Install in the reverse order of the removal.

Vacuum Line Inspection
1. Remove the vacuum hose.. 2. Verify that air can be blown from the power brake unit side of the vacuum hose towards the vacuum pump side, and that air cannot be blown in the opposite direction ...

Vacuum Pump Removal/Installation
1. Remove the plug hole plate.. 2. Remove the battery.. 3. Set the PCM wiring harness out of the way. 4. Disconnect the vacuum hose from the vacuum pump.. 5. Remove in the order shown in the t ...

Other materials:

A Pillar Trim Removal/Installation
1. Partially peel back the seaming welt. 2. Take the shaded area shown in the figure, and pull the A-pillar trim in the direction of the arrow (1) while detaching clip A, clips B. 3. Cut the lead wire connecting clips B and grommet using a nipper. 4. Pull the A-pillar trim in the dir ...

Engine Oil Replacement
WARNING: Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled. A vehicle that is lifted but not securely supported on safety stands is dangerous. It can slip or fall, causing death or serious injury. Never work ...

PCM Removal/Installation
CAUTION: There are two types of PCM settings. If the incorrect PCM is installed, it could cause interference with engine control. When replacing the PCM, verify the first four digits of the part number indicated on the PCM label before replacement, and replace the PCM with one ...

© 2016-2022 Copyright www.mcx5.org