Purpose/Function
The up switch detects the shift up operation of the selector lever.
The up switch signal is sent to the TCM via CAN and is used for manual shift control and engine-transaxle integration control.
Construction
The up switch is installed to the selector lever.
The up switch is an on/off type switch.
Operation
When the selector lever is in the shift up position (+), the up switch contact point closes.
Based on the opening and closing of the up switch contact point, the TCM detects that the shift up has been operated.
Extractor Chamber Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Rear splash shield.
b. Rear combination light.
c. Rear bumper.
3. Insert a tape-wrapped flathead screwdriver shown in the figure and remove
clips in the direction of arrow (1).
4. Remove the extractor cham ...
Steering Gear And Linkage Removal/Installation
CAUTION:
Performing the following procedures without first removing the ABS wheel-speed
sensor may possibly cause an open circuit in the wiring harness if it is pulled
by mistake. Before performing the following procedures, disconnect the ABS wheel-speed
sensor (axle side) and fix t ...
Interior Equipment (View B)
1 Audio control switches
2 SRS air bags
3 Cruise control switches
4 Navigation system (if equipped)
5 Audio system
6 Hazard warning flasher switch
7 Climate control system
8 Glove compartment
9 Rear window defroster switch
10 Accessory socket
11 MT shift lever
12 AT shift lever ...