Purpose
The turn light system flashes the turn light three times automatically according to the turn switch operation.
The front body control module (FBCM) performs turn light system fail-safe..
Function
The front body control module (FBCM) performs control based on the turn switch (RH or LH) signal sent from the start stop unit via the CAN signal as follows:
On-signal receive time of turn switch is less than 0.7 s: Operates the turn light system.
On-signal receive time of turn switch is 0.7 s or more: Flashes the turn light according to the receive time.
Structural view
System wiring diagram
Operation
If the front body control module (FBCM) receives the turn switch on signal from the start stop unit for less than 0.7 s when the ignition is switched ON (engine off or on), it flashes the turn light three times.
If the front body control module (FBCM) receives the turn switch on signal from the previous opposite side during the turn light system operation, it stop the turn light system operation. In addition, if the turn switch on signal on the opposite side is less than 0.7 s, the turn light system does not operate.
Filament Inspection
1. Switch the ignition ON (engine off).
2. Turn the rear window defroster switch on.
CAUTION:
Directly touching the rear window defroster filament with the lead of the
tester could damage it. Wrap aluminum foil around the end of the lead and inspect
the filament by touching it ...
Rear Bumper Disassembly/Assembly
1. Disassemble in the order indicated in the table.
1
Screw
2
Reflector
3
Rear bumper face
2. Assemble in the reverse order of disassembly. ...
Clutch Pipe And Hose Removal/Installation [C66 M R]
CAUTION:
Do not allow clutch fluid to get on a painted surface. Clutch fluid contains
properties which can dissolve the paint. If clutch fluid gets on a painted surface,
wash it off with water immediately and wipe the area off completely.
1. Disconnect the negative battery cable. ...