Mazda CX-5 Service & Repair Manual: Turn And Hazard Indicator Alarm
Purpose
-
The turn and hazard indicator alarm notifies the driver that a turn light or the hazard warning lights are flashing.
Function
-
When the instrument cluster receives the turn signal/hazard warning indicator light illumination request signal sent from the front body control module (FBCM) via the CAN signal, the turn and hazard indicator alarm sounds simultaneously with illumination on/off of the direction/hazard warning indicator lights.
-
The turn and hazard indicator alarm sound pattern is as follows:
|
Sound frequency (Hz) |
Alarm when turn signal/hazard warning indicator lights illumination off > on: 1,400 Alarm when turn signal/hazard warning indicator lights illumination on > off: 1,300 |
|
Sound frequency |
Continuously |
|
Wave pattern |
|
Construction
-
The turn and hazard indicator alarm sounds using the buzzer built into the instrument cluster.
Construction, Operation
1. The instrument cluster receives (1) the turn signal/hazard warning indicator light request signal from the front body control module (FBCM).
2. The instrument cluster microcomputer turns the transistor on (2) based on the turn signal/hazard warning indicator light request signal.
3. When the transistor turns on, a ground circuit with the alarm is established and the alarm sounds (3).
Fail-safe
-
Function not equipped.
Taillight Bulb Removal/Installation
1. Disconnect the negative battery cable..
2. Insert a tape-wrapped flathead screwdriver into the service hole in the position
shown in the figure.
3. Move the flathead screwdriver in the di ...
Turn Signal/Hazard Warning Indicator Lights
Purpose
Notifies the driver that a turn light, the hazard warning lights are flashing.
Function
Flashes according to the turn switch and hazard warning switch operations.
Con ...
Other materials:
Coupling Component Calibration Data Writing
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the toolbox
of the M-MDS.
Select “Chassis”.
3. Then, select items from the screen menu in the following order.
Select “4WD/AWD”.
Select “Coupling Calibra ...
Front Fog Lights Indicator Light
Purpose
Notifies the user that the front fog lights are illuminated.
Function
Illuminates when the front fog light illumination conditions are met.
Construction
Displayed in the instrument cluster.
Operation
1. With the light switch in the TNS, HEAD, or ...
Rear Seat Cushion Trim Removal/Installation
CAUTION:
When removing or putting in the rear seat cushion, contact with the surrounding
areas of the vehicle could cause scratches and damage. When removing or putting
in the rear seat cushion, always use two or more persons to perform the work
and be careful not to scratch or dama ...
