Mazda CX-5 Service & Repair Manual: Turn And Hazard Indicator Alarm
Purpose
-
The turn and hazard indicator alarm notifies the driver that a turn light or the hazard warning lights are flashing.
Function
-
When the instrument cluster receives the turn signal/hazard warning indicator light illumination request signal sent from the front body control module (FBCM) via the CAN signal, the turn and hazard indicator alarm sounds simultaneously with illumination on/off of the direction/hazard warning indicator lights.
-
The turn and hazard indicator alarm sound pattern is as follows:
|
Sound frequency (Hz) |
Alarm when turn signal/hazard warning indicator lights illumination off > on: 1,400 Alarm when turn signal/hazard warning indicator lights illumination on > off: 1,300 |
|
Sound frequency |
Continuously |
|
Wave pattern |
|
Construction
-
The turn and hazard indicator alarm sounds using the buzzer built into the instrument cluster.
Construction, Operation
1. The instrument cluster receives (1) the turn signal/hazard warning indicator light request signal from the front body control module (FBCM).
2. The instrument cluster microcomputer turns the transistor on (2) based on the turn signal/hazard warning indicator light request signal.
3. When the transistor turns on, a ground circuit with the alarm is established and the alarm sounds (3).
Fail-safe
-
Function not equipped.
Tire Pressure Monitoring System Warning Light
Purpose, Function
The tire pressure monitoring system warning light notifies the driver that
it was determined that a tire pressure has decreased below the specified value
based on the in ...
Turn Signal/Hazard Warning Indicator Lights
Purpose
Notifies the driver that a turn light, the hazard warning lights are flashing.
Function
Flashes according to the turn switch and hazard warning switch operations.
Con ...
Other materials:
Clock Spring Inspection [Two Step Deployment Control System]
1. Disconnect the negative battery cable and wait for 1 min or more..
2. Remove the driver?side air bag module..
3. Remove the steering wheel..
4. Remove the column cover..
5. Remove the clock spring..
6. Verify that the continuity is as indicated in the table.
If not as indicated ...
Light Switch Inspection
Light Switch
1. Disconnect the negative battery cable..
2. Remove the column cover..
3. Remove the light switch..
4. Verify that the continuity between the light switch terminals is as indicated
in the table.
Vehicles without auto light system
Vehicles with auto light system
...
Rear Wiper Motor Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Rear wiper arm and blade.
b. Liftgate upper trim.
c. Liftgate side trim.
d. Liftgate recess.
e. Liftgate lower trim.
3. Remove the rear wiper motor connector.
4. Remove bolts shown in the figure.
5 ...
