Purpose/Function
The turbine/input shaft speed sensor detects the rotation speed of the input shaft (low clutch drum).
The output shaft speed sensor detects the rotation speed of the output shaft (primary gear).
The turbine/input shaft speed sensor and output shaft speed sensor signals are used for automatic shift control, manual shift control, and the on-board diagnostic system.
Construction
The turbine/input shaft speed sensor and output shaft speed sensor are both integrated with the TCM and built-into the control valve body.
Operation
The turbine/input shaft speed sensor changes the output signal according to the rotation speed of the low clutch drum.
The output shaft speed sensor changes the output signal according to the rotation speed of the primary gear.
Transfer Oil Replacement [Fw6 Ax EL]
1. Remove the front under cover No.2..
2. Remove the drain plug with the washer.
3. Drain the oil into a suitable container.
4. Tighten the drain plug with a new washer.
Tightening torque
40—58 N·m {4.1—5.9 kgf·m, 30—42 ft·lbf}
5. Remove the oil level plug with ...
Front Door Trim Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the inner garnish..
3. Insert a tape-wrapped flathead screwdriver in the position indicated by the
arrow (1) in the figure and remove the inner handle cover while detach tabs A, pin
B.
4. Remove the screw C.
5. Remove the cover ...
Antenna Feeder No.2 Removal/Installation
Removal
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Sunroof seaming welt (with sunroof system).
b. A-pillar trim.
c. Front map light.
d. Sunvisor.
e. Front scuff plate.
f. Rear scuff plate.
g. B-pillar lower trim.
h. Adjust anchor cover.
i. Upper ...