Mazda CX-5 Service & Repair Manual: Transfer Oil Seal Replacement [Fw6 Ax EL]
Transfer oil seal (LH)
1. Drain the transfer oil..
2. Remove the transfer from the vehicle..
3. Insert a tape-wrapped flathead screwdriver into the lip area of the oil seal (LH) as shown in the figure and remove the oil seal (LH).
4. Using the SST
and a hammer, tap the new seal into place.
5. Apply the lip of the oil seal with transfer oil.
6. Install the transfer to the vehicle..
7. Add the specified amount and type of oil..
Transfer oil seal (RH) No.1
1. Remove the front drive shaft (RH)..
2. Insert a flathead screwdriver into the notch of the transfer and remove the oil seal (RH) No.1.
3. Using the SST
and a hammer, tap the new seal into place.
4. Coat the lip of the oil seal with transfer oil.
5. Install the front drive shaft (RH)..
Transfer oil seal (RH) No.2
1. Drain the transfer oil..
2. Remove the front drive shaft (RH)..
3. Remove the transfer oil seal (RH) No.1..
4. Insert a tape-wrapped flathead screwdriver into the lip area of the oil seal (RH) No.2 as shown in the figure and remove the oil seal (RH) No.2.
5. Using the SST
and a hammer, tap the new seal into place.
6. Apply the lip of the oil seal with transfer oil.
7. Install the transfer oil seal (RH) No.1..
8. Install the front drive shaft (RH)..
9. Add the specified amount and type of oil..
Transfer oil seal (RH) No.3
1. Drain the transfer oil..
2. Remove the front drive shaft (RH)..
3. Remove the transfer oil seal (RH) No.1..
4. Remove the oil seals using a tape-wrapped flathead screwdriver.
5. Using the SST
and a hammer, tap the new seal into place.
6. Apply the lip of the oil seal with transfer oil.
7. Install the transfer oil seal (RH) No.1..
8. Install the front drive shaft (RH)..
9. Add the specified amount and type of oil..
Transfer Oil Replacement [Fw6 Ax EL]
1. Remove the front under cover No.2..
2. Remove the drain plug with the washer.
3. Drain the oil into a suitable container.
4. Tighten the drain plug with a new washer.
Tightening ...
Transfer Removal/Installation [Fw6 Ax EL]
CAUTION:
Performing the following procedures without first removing the front ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before ...
Other materials:
Center Roof Antenna Inspection
NOTE:
The center roof antenna is integrated with the antenna amplifier.
Antenna amplifier inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate.
b. Rear scuff plate.
c. B-pillar lower trim.
d. Front seat belt adjusting cove ...
Front Center Speaker Inspection
1. Disconnect the negative battery cable..
2. Remove the center speaker grille..
3. Remove the front center speaker..
4. Verify that the resistance between the front center speaker terminals is as
indicated in the table.
If not as indicated in the table, replace the front center ...
Magnetic Clutch Adjustment [Full Auto Air Conditioner]
1. Measure the clearance around the entire circumference between the pressure
plate and A/C compressor pulley using a thickness gauge.
2. Verify the clearance.
If not within the specification, remove the pressure plate and adjust the
clearance by changing the shim (0.2 mm {0.008 i ...
