Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Tire Pressure Monitoring System (TPMS)

Mazda CX-5 Service & Repair Manual / Suspension / Wheels, Tires / Tire Pressure Monitoring System (TPMS)

Purpose, Outline

System structural view


System wiring diagram


Function


Part name

Function

DSC HU/CM

  • Calculates the change in tire pressure based on the signals from each sensor and monitors the change in status.

  • When it is determined that a tire pressure decreases below the specified value based on the initialization, the tire pressure monitoring system warning light is illuminated.

  • The tire pressure monitoring system warning light illumination signal is sent to the instrument cluster via a CAN signal.

  • If a malfunction occurs in the tire pressure monitoring system, determination is made to flash the tire pressure monitoring system warning light.

  • The tire pressure monitoring system warning light flash signal is sent to the instrument cluster via a CAN signal.

ABS wheel-speed sensor

  • The wheel speed is sent to the DSC HU/CM.

Ambient temperature sensor

  • The ambient temperature is sent to the PCM.

PCM

  • The ambient temperature is sent to the DSC HU/CM via a CAN signal.

PCM

BARO sensor

  • The atmospheric pressure is sent to the DSC HU/CM via a CAN signal.

Instrument cluster

Tire pressure monitoring system warning light

  • The tire pressure monitoring system warning light illuminates by the illumination signal from the DSC HU/CM.

  • The tire pressure monitoring system warning light flashes for approx. 1 min by the flash signal from the DSC HU/CM, and then it illuminates.

Tire pressure monitoring system warning alarm

  • The tire pressure monitoring system warning alarm sound is triggered by the warning alarm request signal from the DSC HU/CM.

Instrument cluster

  • The initialization signal is sent to the DSC HU/CM via a CAN signal.

Tire pressure monitoring system set switch

  • The initialization signal is sent to the instrument cluster.


Operation

The tire pressure monitoring system operates as shown in the following figure.


Mis-use prevention logic

Tire pressure monitoring system warning light does not illuminate

Tire pressure monitoring system does not operate normally

Wheels And Tires
Outline An adhesive-type balance weights has been adopted to the outer side of the aluminum alloy wheels. Due to this, a stylish wheel design is realized. In consideration of the e ...

Tire Pressure Monitoring System Initialization Procedure
Perform the tire pressure monitoring system initialization when the following operations have been performed: Tire pressures have been adjusted Tires or wheels have ...

Other materials:

Side Turn Light
Purpose The side turn lights are used to signal vehicles/people at the side of the vehicle that the vehicle is going to make a right or left turn. Function The side turn lights flash according to the operation of the turn or the hazard switch. Construction Side ...

Engine Oil Level Inspection
1. Position the vehicle on level ground. 2. Warm up the engine. 3. Stop the engine and allow at least 5 min before continuing. 4. Remove the dipstick, wipe it cleanly, and reinstall it fully. 5. Remove the dipstick and verify that the oil level is between the F and L marks on the dipstick. ...

TCM Configuration [Fw6 A EL, Fw6 Ax EL]
NOTE: The TCM is built into the control valve body. 1. Verify TCM configuration implementation necessity for replacement parts. Replacement part Configuration necessity Control valve body replacement Necessary ...

© 2016-2024 Copyright www.mcx5.org