Mazda CX-5 Service & Repair Manual: Tire Pressure Monitoring System Set Switch Inspection
1. Remove the TPMS set switch..
2. Verify that the resistance between the TPMS set switch terminals B and C is as indicated in the table.
-
If not as indicated in the table, replace the TPMS set switch.
TPMS set switch specification
|
Terminal |
Test condition |
Resistance (ohms) |
|
B—C |
Switch pressed |
187.61—191.39 |
|
Switch released |
1139.99—1163.01 |
3. Apply battery voltage to TPMS set switch terminal J, and connect terminal I to ground.
4. Verify that the LED illuminates.
-
If there is any malfunction, replace the TPMS set switch.
Tire Pressure Monitoring System Set Switch
Purpose
The tire pressure monitoring system set switch is used to initialize the
tire pressure monitoring system.
Construction, Operation
The tire pressure monitoring syst ...
Tire Pressure Monitoring System Set Switch Removal/Installation
NOTE:
The tire pressure monitoring system (TPMS) set switch is integrated with
the cluster switch.
Refer to SWITCH PANEL REMOVAL/INSTALLATION to remove the cluster switch.
...
Other materials:
Rear Body Control Module (Rbcm) Configuration (Using As Built Data)
NOTE:
If the configuration is performed using As-Built data, the set value of the
personalization function is reset to the initial value (condition when shipped
from factory). Verify the set value with the customer and perform the personalization
function setting after performing th ...
Suspension Abbreviations
AAS
Active Adaptive Shift
ABS
Antilock Brake System
ABDC
After Bottom Dead Center
ACC
Accessories
AFS
Adaptive Front Lighting System
ALC
...
Scheduled Maintenance (Mexico)
Follow Schedule 1 if the vehicle is operated mainly where none of the following
conditions apply.
• Repeated short-distance driving
• Driving in dusty conditions
• Driving with extended use of brakes
• Driving in areas where salt or other corrosive
materials are used
• Driving on ...
