Mazda CX-5 Service & Repair Manual: Tire Pressure Monitoring System Set Switch

Tire Pressure Monitoring System Initialization Procedure

Perform the tire pressure monitoring system initialization when the following operations have been performed: Tire pressures have been adjusted Tires or wheels have ...

Tire Pressure Monitoring System Set Switch Inspection

1. Remove the TPMS set switch.. 2. Verify that the resistance between the TPMS set switch terminals B and C is as indicated in the table. If not as indicated in the table, replace the TP ...

Other materials:

Audio Pilot®2 Microphone Removal/Installation
NOTE: AudioPilot®2 is a registered trademark of Bose® Corporation. 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Driver-side front scuff plate. b. Driver-side front side trim. c. Switch panel. d. Decoration panel. e. Shift lever knob (MTX). ...

Back Up Light Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure. 3. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, pull out the service hole cover from the liftgate, a ...

Floor Side Panel Removal [Panel Replacement]
Symbol Mark Removal Procedure 1. Drill the 35 locations indicated by (A) shown in the figure, then remove the floor side panel No.1. 2. Drill the 5 locations indicated by (B) shown in the figure. 3. Drill the 4 locations indicated by (C) from rear wheel housing shown in the figure. ...