1. Remove the snap pin.
2. Loosen the tie-rod end locknut.
3. Detach the tie-rod end from the steering knuckle using the SST
.
4. Remove the tie-rod end locknut.
5. Place alignment marks as shown in the figure for proper installation.
6. Remove the tie-rod end.
7. Align the alignment marks made before removing the tie-rod end, and then install a new tie-rod end to the tie rod.
If there are no alignment marks, go to the following procedure.
8. Adjust dimension A shown in the figure to the standard, and assemble.
10.1—23.1 mm {0.398—0.909 in}
9. Install the tie-rod end to the steering knuckle.
10. Install a new snap pin.
11. After installation, inspect the front wheel alignment and adjust it if necessary..
Camshaft Position (CMP) Sensor
Purpose/Function
Detects the camshaft speed as basic information for mainly determining the
fuel injection timing and ignition timing.
Detects the camshaft speed and inputs it to the PCM as a CMP signal.
Construction
Intake CMP sensor
Installed on the cylinder head.
...
Outside the United States/Canada
Government regulations in the United States/Canada require that automobiles meet
specific emission regulations and safety standards. Therefore, vehicles built for
use in the United States/Canada may differ from those sold in other countries.
The differences may make it difficult or even impossi ...
Audio Amplifier
Purpose, Function
The audio signal (analog voltage waveform) output from the unit equipped
on the vehicle is converted into a digital pulse. The converted digital pulse
signal is amplified and sent to the speakers.
Construction
The audio amplifier is placed in the front sid ...