Mazda CX-5 Service & Repair Manual: Tie Rod End Inspection
1. Inspect the tie-rod end for damage and the boot for cracks.
-
If there is any malfunction, replace the tie-rod end.
2. Inspect for excessive play.
-
If there is any malfunction, replace the tie-rod end.
3. Rotate the tie-rod end five times.
4. Install two nuts to the ball joint and measure the tie-rod end rotational torque using a torque wrench.
-
If not within the specification, replace the tie-rod end.
-
Tie-rod end rotational torque
-
0.5—2.1 N·m {5.1—21 kgf·cm, 4.5—18 in·lbf}
Steering Shaft Inspection
1. Inspect the steering column for excessive play and damage.
2. Verify that the clearance between the projection on the steering column shown
in the figure and the bracket is less than 2.0 mm {0. ...
Tie Rod End Replacement
1. Remove the snap pin.
2. Loosen the tie-rod end locknut.
3. Detach the tie-rod end from the steering knuckle using the SST.
4. Remove the tie-rod end locknut.
5. Place alignment mark ...
Other materials:
Rear Lower Arm Removal/Installation
WARNING:
Be careful not to allow the coil spring to fly off when removing/installing
the coil spring. Otherwise, the coil spring could fly off and cause serious
injury or death, or damage to the vehicle.
1. When working on the left side of the vehicle, disconnect the auto lev ...
Control System Personalization Features Setting Procedure
1. Connect the M-MDS to DLC-2.
2. After the vehicle is identified, select the following items from the initial
screen of the M-MDS.
Select the “Module Programming”.
Select “Programmable Parameters”.
Select menu in the R_BCM.
3. Select an item name, and then ...
Shift Lever [C66 M R]
Purpose, Function
The shift lever operates the MTX via the control cable.
Construction
Shift lever
The shift lever is designed to prevent improper shifting to 1st gear and
reverse.
Operation
1 GR shifting
A guide plate, attached to the shift lever assembly, ...
