Mazda CX-5 Service & Repair Manual: Throttle Body Inspection
Resistance Inspection
1. Disconnect the negative battery cable..
2. Disconnect the throttle body connector.
3. Measure the resistance between throttle body terminals E and F.
-
Throttle body resistance
-
1.38 ohms [20°C {68 °F}]
-
If not as specified, replace the throttle body..
Start Stop Unit Removal/Installation
CAUTION:
If configuration is not performed when the start stop unit is replaced with
a new one, the vehicle specification information is not stored in the start
stop unit and the system ...
Throttle Body
Purpose, Function
Opens/closes the throttle valve to adjust the amount of air supplied to the
cylinder.
Opens/closes the throttle valve according to the control signal from the
PC ...
Other materials:
Hazard Warning Switch Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the decoration panel..
3. While pressing the hazard warning switch tab in the direction of the arrow
(1) shown in the figure, press the hazard warning switch in the direction of the
arrow (2) shown in the figure to detach the hazard warnin ...
Keyless Warning Alarm
Purpose
The keyless warning alarm notifies the driver that the remote transmitter
cannot be verified or the steering lock cannot be released.
Function
When the instrument cluster receives the keyless warning alarm request signal
sent from the start stop unit via the CAN sig ...
Air Fuel Ratio (A/F) Sensor
Purpose/Function
Detects the oxygen concentration (all-range air/fuel ratio) in the exhaust
gas as basic information for mainly determining the fuel injection amount.
Detects the oxygen concentration (all-range air/fuel ratio) in the exhaust
gas and inputs it to the PCM as an ox ...
