Mazda CX-5 Service & Repair Manual: Throttle Body

Mazda CX-5 Service & Repair Manual / Engine / Control / Throttle Body

Purpose, Function

Opens/closes the throttle valve to adjust the amount of air supplied to the cylinder.
Opens/closes the throttle valve according to the control signal from the PCM.

Construction

The throttle body is installed to the intake manifold.
The throttle body consists of a throttle valve, throttle valve actuator, TP sensor, and return spring.
For the throttle position sensor, refer to CONTROL SYSTEM..

Operation

The throttle valve actuator opens/closes the throttle valve according to the control signal from the PCM. If there is a malfunction in the throttle valve actuator, the throttle valve is closed by the return spring in the throttle body.
For the drive-by-wire control, refer to CONTROL SYSTEM..

Fail-safe


DTC	Fail-safe
P2101:00	Stops the idle air control. Stops the drive-by-wire control and sets to a throttle valve opening angle necessary for minimum driveability.
P2107:00	Stops the idle air control. Stops the drive-by-wire control and sets to a throttle valve opening angle necessary for minimum driveability.
P2110:00	Stops the idle air control. Stops the drive-by-wire control and sets to a throttle valve opening angle necessary for minimum driveability.
P2112:00	Stops the idle air control. Stops the drive-by-wire control and sets to a throttle valve opening angle necessary for minimum driveability.
P2119:00	Restricts the upper limit of the engine speed.

Throttle Body Inspection

Resistance Inspection 1. Disconnect the negative battery cable.. 2. Disconnect the throttle body connector. 3. Measure the resistance between throttle body terminals E and F. Throttle bo ...

Throttle Position (TP) Sensor Inspection

Voltage Inspection CAUTION: The inspection cannot be performed with this method correctly if there is a malfunction of the APP sensor or throttle valve actuator. Verify that no DTCs rel ...

Other materials:

Filament Inspection
1. Switch the ignition ON (engine off). 2. Turn the rear window defroster switch on. CAUTION: Directly touching the rear window defroster filament with the lead of the tester could damage it. Wrap aluminum foil around the end of the lead and inspect the filament by touching it ...

PCM Removal/Installation
CAUTION: There are two types of PCM settings. If the incorrect PCM is installed, it could cause interference with engine control. When replacing the PCM, verify the first four digits of the part number indicated on the PCM label before replacement, and replace the PCM with one ...

Differential [C66 M R]
Purpose, Function The differential absorbs the rotation speed of the inside and outside wheel of a wheel set when the vehicle is cornering. Construction Operation Driving in a straight line Cornering ...