Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Thermostat Removal/Installation

Mazda CX-5 Service & Repair Manual / Engine / Cooling / Thermostat Removal/Installation

WARNING:

1. Disconnect the negative battery cable..

2. Drain the engine coolant..

3. Remove the plug hole plate..

4. Remove the air cleaner, air hose and fresh air duct component..

5. Remove the battery, battery tray and PCM component..

6. Remove in the order indicated in the table.

7. Install in the reverse order of removal.

8. Refill the engine coolant..

9. Inspect for engine coolant leakage..



1

Lower radiator hose (Thermostat cover side)

2

Thermostat cover

(See Thermostat Cover Removal Note.)

3

Thermostat

(See Thermostat Installation Note.)


Thermostat Cover Removal Note

1. Place rags on the transaxle case around the area under the thermostat cover.

2. Slightly loosen the three

thermostat cover bolts and use the rags to absorb the draining engine coolant.

CAUTION:

3. After the engine coolant stops draining, remove the thermostat cover.

Thermostat Installation Note

1. Install the thermostat with the jiggle pin aligned with the notch of the water outlet.


Thermostat Inspection
1. Remove the thermostat.. 2. Visually check that the thermostat valve is closed. 3. Place the thermostat in water. WARNING: During inspection, the thermostat and water are extremely hot ...

Thermostat
Purpose, Function When the engine coolant temperature is low, the thermostat blocks the engine coolant passage between the radiator and engine. As a result, because engine coolant cycles ...

Other materials:

Front Seat
Seat Operation 1 Seat Slide (Manual Seat) To move a seat forward or backward, raise the lever and slide the seat to the desired position and release the lever. Make sure the lever returns to its original position and the seat is locked in place by attempting to push it forward and backward. ...

A/C Unit Removal/Installation
1. Disconnect the negative battery cable.. 2. Discharge the refrigerant.. 3. Drain the engine coolant.. CAUTION: If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal noise or other malfunction could occur. Always plug open f ...

Engine Coolant Temperature (ECT) Sensor
Purpose/Function Detects the ECT as basic information for mainly determining the fuel injection amount. Detects the ECT and inputs it to the PCM as an ECT signal. The ECT sensor No.2 is only used for OBD. Construction ECT sensor No.1 Installed to the water out ...

© 2016-2024 Copyright www.mcx5.org