Mazda CX-5 Service & Repair Manual: Tcs Off Switch, Tcs Off Indicator Light
Purpose/Function
-
The TCS OFF switch, located on the dashboard, allows for optionally enabling/disabling the TCS control at driver discretion.
-
The TCS OFF indicator light, built into the instrument cluster, informs the driver that TCS control has been disabled by operation of the TCS OFF switch.
Operation
-
When the DSC system and CAN lines are functionally normally, the TCS OFF indicator light illuminates for approx. 3.0 s when the ignition is switched to ON to check the light function.
-
When the TCS OFF switch is pressed to disable TCS control, the TCS OFF indicator light illuminates.
NOTE:
-
To inhibit the TCS control, continue to press the TCS OFF switch until the TCS OFF indicator light illuminates.
-
The TCS OFF indicator light illumination and TCS/DSC/roll over mitigation (ROM) control conditions while operating the TCS OFF switch are as indicated in the table.
|
TCS OFF indicator light illumination conditions |
TCS control conditions |
DSC control conditions |
Roll over mitigation (ROM) control conditions |
||
|
Brake control |
Engine control |
||||
|
TCS ON |
Not illuminated |
Permitted |
Permitted |
Permitted |
Permitted |
|
TCS OFF |
Illuminated |
Permitted |
Inhibited |
Permitted |
Permitted |
Fail-safe
|
DTC No. |
Fail-safe function |
|
C0089:64 |
|
Shift Position Indicator Light [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The shift position indicator light indicates the selector lever position.
Construction
The shift position indicator light is built into the instrument cluster.
...
Tcs/DSC Indicator Light
Purpose/Function
The TCS/DSC indicator light, built into the instrument cluster, informs the
driver of the following vehicle conditions.
TCS is operating. (Drive wheel is slippi ...
Other materials:
Filament Repair
1. Clean the filament using isopropyl alcohol.
2. Attach tape to both sides of the filament.
3. Using a small brush or marking pen, apply silver paint.
4. After 2—3 min, carefully remove the tape without damaging the applied
area.
CAUTION:
Do not operate the rear window defro ...
Glass Antenna Inspection
1. Disconnect the negative battery cable..
2. Partially peel back the seaming welt.
3. Remove the liftgate upper trim..
4. Disconnect antenna feeder No.3 connector..
5. Visually inspect the glass antenna for damage.
6. Verify that the continuity between the glass antenna terminals is as in ...
Auto Leveling Sensor
Purpose
Detects the vehicle height and outputs it to the AFS control module.
Function
Changes the detected vehicle height into a voltage value and outputs it to
the AFS control module.
Construction
Installed to the rear cross member.
Consists of link No. 1 ...
