Mazda CX-5 Service & Repair Manual: Tcs Off Switch Removal/Installation
NOTE:
-
The TCS OFF switch is integrated with the cluster switch.
-
Refer to SWITCH PANEL REMOVAL/INSTALLATION to remove the cluster switch.
1. Remove the cluster switch from the switch panel..
2. Install in the reverse order of removal.
Tcs Off Switch Inspection
1. Remove the TCS OFF switch..
2. Verify that the resistance between the TCS OFF switch terminals B and C is
as indicated in the table.
If not as indicated in the table, replace the TCS OF ...
Tcs Off Switch, Tcs Off Indicator Light
Purpose/Function
The TCS OFF switch, located on the dashboard, allows for optionally enabling/disabling
the TCS control at driver discretion.
The TCS OFF indicator light, built ...
Other materials:
Accessory Sockets
Only use genuine Mazda accessories or the equivalent requiring no greater than
120 W (DC 12 V, 10 A).
Front
The ignition must be switched to ACC or ON.
Center, Rear
The accessory sockets can be used regardless of whether the ignition is on or
off.
CAUTION
●To prevent accessory ...
Theft Deterrent Horn Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk end trim.
b. Rear scuff plate (RH).
c. Trunk side trim (RH).
d. Theft-deterrent horn.
3. Apply battery positive voltage to horn terminal A, and connect the horn retaining
bolt to ground as shown in the f ...
DSC HU/CM
Outline
A high reliability, reduced size and weight DSC HU/CM, integrating both the
DSC HU and the DSC CM, has been adopted.
DSC HU Part Purpose/Function
According to DSC CM signals, the DSC HU controls (on/off) each solenoid valve
and the pump motor, adjusts fluid pr ...
