Mazda CX-5 Service & Repair Manual: Tcs/DSC Indicator Light
Purpose/Function
-
The TCS/DSC indicator light, built into the instrument cluster, informs the driver of the following vehicle conditions.
-
TCS is operating. (Drive wheel is slipping.)
-
DSC is operating. (Vehicle side-slip condition.)
-
Roll over mitigation (ROM) is operating.
-
DSC system malfunction.
Operation
-
When the DSC system and CAN lines are normal, the TCS/DSC indicator light illuminates for approx. 3.0 s when the ignition is switched to ON to check the light function. When the system is malfunctioning, the TCS/DSC indicator light remains illuminated.
-
When the TCS, DSC or roll over mitigation (ROM) are non-operational, operational and malfunctioning, the TCS/DSC indicator light operates according to the following table.
TCS/DSC indicator light operation
|
Item |
TCS/DSC indicator light |
|
TCS, DSC, and roll over mitigation (ROM) not operating
|
Not illuminated |
|
TCS operating
|
Flashes (0.5 s intervals) |
|
DSC operating
|
|
|
Roll over mitigation (ROM) operating
|
|
|
DSC system malfunction
|
Illuminated |
Fail-safe
-
Function not equipped.
Tcs Off Switch, Tcs Off Indicator Light
Purpose/Function
The TCS OFF switch, located on the dashboard, allows for optionally enabling/disabling
the TCS control at driver discretion.
The TCS OFF indicator light, built ...
ABS
...
Other materials:
Cowl Panel Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Windshield wiper arm and blade.
b. Cowl grille.
c. Windshield wiper motor.
d. Keyless beeper.
3. Remove clips A.
4. Remove bolts B.
5. Remove the cowl panel in the direction of the arrow shown in the fig ...
Air Intake Actuator Inspection [Full Auto Air Conditioner]
1. Connect battery positive voltage to air intake actuator terminal B (or C),
connect terminal C (or B) to ground, and then verify that the air intake actuator
operates as shown in the table.
If the operation condition is not normal, replace the air intake actuator.
...
Air Intake Actuator Inspection [Manual Air Conditioner]
1. Connect battery positive voltage to air intake actuator terminal B (or C),
connect terminal C (or B) to ground, and then verify that the air intake actuator
operates as shown in the table.
If the operation condition is not normal, replace the air intake actuator.
...
