Mazda CX-5 Service & Repair Manual: Tcs/DSC Indicator Light
Purpose/Function
-
The TCS/DSC indicator light, built into the instrument cluster, informs the driver of the following vehicle conditions.
-
TCS is operating. (Drive wheel is slipping.)
-
DSC is operating. (Vehicle side-slip condition.)
-
Roll over mitigation (ROM) is operating.
-
DSC system malfunction.
Operation
-
When the DSC system and CAN lines are normal, the TCS/DSC indicator light illuminates for approx. 3.0 s when the ignition is switched to ON to check the light function. When the system is malfunctioning, the TCS/DSC indicator light remains illuminated.
-
When the TCS, DSC or roll over mitigation (ROM) are non-operational, operational and malfunctioning, the TCS/DSC indicator light operates according to the following table.
TCS/DSC indicator light operation
|
Item |
TCS/DSC indicator light |
|
TCS, DSC, and roll over mitigation (ROM) not operating
|
Not illuminated |
|
TCS operating
|
Flashes (0.5 s intervals) |
|
DSC operating
|
|
|
Roll over mitigation (ROM) operating
|
|
|
DSC system malfunction
|
Illuminated |
Fail-safe
-
Function not equipped.
Tcs Off Switch, Tcs Off Indicator Light
Purpose/Function
The TCS OFF switch, located on the dashboard, allows for optionally enabling/disabling
the TCS control at driver discretion.
The TCS OFF indicator light, built ...
Tire Pressure Monitoring System Warning Light
Purpose, Function
The tire pressure monitoring system warning light notifies the driver that
it was determined that a tire pressure has decreased below the specified value
based on the in ...
Other materials:
Operating Tips
Operate the climate control system with the engine running.
• To prevent the battery from being discharged,
do not leave the fan control dial on for a long period of time with the ignition
switched ON when the engine is not running.
• Clear all obstructions such as leaves, snow
and ice f ...
Clutch Fluid Inspection [C66 M R]
NOTE:
A common reserve tank is used for the clutch system and brake system.
1. Verify that the clutch fluid is between the MIN mark and the MAX mark.
Verify that there is no clutch fluid leakage then add clutch fluid to the
level between the MIN mark and the MAX mark..
...
Clock Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Shift lever knob (MTX).
b. Front console box.
c. Shift panel.
d. Upper panel.
e. Rear console.
f. Side wall.
g. Decoration panel.
h. Front console.
i. Glove compartment.
j. Climate control unit.
3. C ...
