Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Taillight Bulb Removal/Installation

Mazda CX-5 Service & Repair Manual / Body / Lighting & Horn / Exterior / Taillight Bulb Removal/Installation

1. Disconnect the negative battery cable..

2. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure.


3. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, pull out the service hole cover from the liftgate, and detach the service hole cover tab and liftgate.


4. Pull out the service hole cover in the direction of the arrow (2) shown in the figure and pull out the service hole cover hook from the liftgate.


5. Remove the service hole cover.

6. Rotate the socket in the direction of the arrow (3) shown in the figure and remove it from the liftgate light in the direction of the arrow (4) shown in the figure.


7. Remove the taillight bulb.


8. Install in the reverse order of removal.

Rear Side Marker Light Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure. 3. Move the flathead screwdriver in the di ...

Turn And Hazard Indicator Alarm
Purpose The turn and hazard indicator alarm notifies the driver that a turn light or the hazard warning lights are flashing. Function When the instrument cluster receives the tu ...

Other materials:

Clutch Cover Inspection [C66 M R]
1. Remove the clutch cover.. 2. Perform the following procedures to inspect the clutch cover. If it exceeds the maximum specification, replace the clutch cover.. a. Measure the wear of the diaphragm spring fingers. Clutch cover diaphragm spring fingers maximum depth 0.6 ...

Control Valve Body [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The control valve body controls the hydraulic pressure generated by the oil pump by each solenoid valve. In addition, the oil passages which introduce hydraulic pressure to the pistons for each clutch and brake is formed by the switching of each built-in shift valve. ...

Automatic Transaxle Fluid (ATF) Replacement [Fw6 A EL, Fw6 Ax EL]
WARNING: Do not perform the servicing while the ATF is hot. Otherwise, it could cause severe burns or serious injury. 1. Remove the front under cover No.2.. 2. Remove the dipstick securing bolt. 3. Remove the dipstick. 4. Remove the drain plug and washer, and drain the ATF ...

© 2016-2022 Copyright www.mcx5.org