Mazda CX-5 Service & Repair Manual: Supplier Identification Procedure [Audio]
NOTE:
-
The unit supplier can vary. When asking the supplier (service center) for repair or replacement, identify the supplier and fill in the Audio Repair Order Form using the following procedures.
Verification procedure using label or inscribed lettering
1. Disconnect the negative battery cable..
2. Remove the decoration panel..
3. Remove the audio unit..
4. Verify the supplier name by referring to the label attached to the unit.
Audio unit (with color LCD)
Audio unit (without color LCD)
Verification procedure using on-board diagnostic assist function
Audio unit (with color LCD)
1. Switch the ignition to ACC or ON (engine off).
2. Verify that the audio is turned on. If the audio is turned off, press the POWER/VOLUME switch to turn it on.
3. Press the POWER/VOLUME switch and SEEK switch (up) simultaneously to launch the diagnostic assist function.
4. Verify that the launched diagnostic assist function is displayed on the screen.
5. Input diagnostic assist code "06".
6. Select "ENTER switch".
7. Identify the supplier code by referring to the display.
|
Supplier code |
Supplier name |
|
M-01 |
SANYO Automedia |
|
M-02 |
Panasonic |
|
M-03 |
Clarion |
|
M-04 |
Pioneer |
|
M-05 |
VISTEON |
8. Press the POWER/VOLUME switch and return to the diagnostic assist screen.
9. Press the POWER/VOLUME switch and end the diagnostic assist function.
Audio unit (without color LCD)
1. Switch the ignition to ACC or ON (engine off).
2. Verify that the audio is turned on. If the audio is turned off, press the POWER/VOLUME switch to turn it on.
3. Press PRESET switch 5 for 3 s or more while simultaneously pressing the POWER/VOLUME switch to launch the supplier verification mode.
4. Identify the supplier code by referring to the audio display.
|
Supplier code |
Supplier name |
|
M-01 |
SANYO Automedia |
|
M-02 |
Panasonic |
|
M-03 |
Clarion |
|
M-04 |
Pioneer |
|
M-05 |
VISTEON |
5. Switch the ignition off (LOCK) to complete the manufacturer code verification mode.
Speaker [Without Bose®]
Purpose
Converts the audio signal from the audio unit to sound.
Function
Full-range speakers, which can output wide-range sound from low to high frequency,
have been adopted.
...
Tweeter Inspection
1. Disconnect the negative battery cable..
2. Remove the side speaker grille..
3. Remove the tweeter..
4. Verify that the resistance between the tweeter terminals is as indicated in
the table. ...
Other materials:
Rear Accessory Socket Removal/Installation
1. Disconnect the negative battery cable..
2. Insert a tape-wrapped flathead screwdriver into the service hole in the position
shown in the figure.
3. Move the flathead screwdriver in the direction of the arrow (1) shown in the
figure, pull out the service hole cover, and detach the serv ...
Windshield Installation
WARNING:
Using a utility knife with bare hands can cause injury. Always wear gloves
when using a utility knife.
CAUTION:
If a door is opened or closed when all the window glass is closed, the resulting
change in air pressure could cause the sealant to crack preventing the ...
Body Panel
Outline
The multi-load path and triple H-shaped structure of distributing the power
absorbed at the collision were used for the body shell.
A ring structure has been adopted for the triple H structure, realizing top-level
crash safety performance.
Crushable structure fro ...
